Read Sharp PN-ZB01 (serv.man2) Service Manual online
CHAPTER 6. FIRMWARE UPDATA PROCEDURES/EDID WRITING PROCEDURES
PN-E601 FIRMWARE UPDATA PROCEDURES/EDID WRITING PROCEDURES
6 – 2
1 - 2. FIRMWARE UPDATE
1 ) Press [Main Firmware] button of the Service Tool Launcher.
The library (CGProbe5.3.0.1.dll) is registered, and the updater starts up.
2 ) Select the COM port to be used for communication.
(“COM1” on the above screen)
3 ) Set the batch file name as “C:./isp_flash16_ext.txt”.
(It is set as the default. Do not change it.)
4 ) Press [BATCH] button, and the firmware writing is started.
For about 3 minutes and writing is completed. When “Firmware
version up completed” is displayed, the firmware update is com-
pleted.
MEMO
n
Very occasionally it takes about 8 minutes to write the firmware
on Windows Vista
on Windows Vista
5 )
The new version firmware can be operated by turning OFF and ON
the main power.
6 ) When [BATCH] button is pressed with the other model connected,
the following “ERROR !!! “Wrong Model Type”” message is dis-
played. Check to confirm the connected model of information mon-
itor.
itor.
■ WHEN UPDATING IS FAILED
First, turn OFF the main power and then turn it ON again. Then, press
[BATCH2] button to start writing the firmware. (Don’t press [BATCH3].)
In about 4 minutes, updating is completed and “Firmware update com-
pleted” is displayed. It is the end of firmware updating.
pleted” is displayed. It is the end of firmware updating.
MEMO
n
Very occasionally it takes about 8 minutes to write the firmware
on Windows Vista.
After completion of firmware updating, turn OFF and ON the main
power, and the new version firmware is operated.
Click on the first or last page to see other PN-ZB01 (serv.man2) service manuals if exist.