Read Sharp PN-60TA3 (serv.man5) Service Manual online
PN-L703A/L703B, PN-70TA3/70TB3, PN-L603A/L603B, PN-60TA3/60TB3
INSTALLATION, ADJUSTMENT, SETTING 2 - 5
2. LAN cable (commercially available, straight) is directly connected to the PC
Your monitor can be connected to a LAN allowing you to control it from a PC on the LAN.
You can also configure the monitor to send e-mail notification when it has a problem.
The connection requires a commercially available LAN cable (UTP cable, Category 5, straight through).
(MEMO)
- You must assign an IP address to the monitor by following the procedures in
“Settings to connect to a LAN”. (See the description on the
right.)
- Your PC must be installed with Internet Explorer (version 7.0 or later).
Version 7, 8, or 9 of Internet Explorer is recommended.
Use Internet Explorer Version 10 in compatibility mode.
- When STANDBY MODE is set to LOW POWER, control is not possible in standby mode.
1 – 4.CONNECTING THE POWER CORD
(Caution)
- Use only the power cord supplied with the monitor.
1 ) Turn off the main power switch.
2 ) Plug the power cord (supplied) into the AC input terminal.
3 ) Plug the power cord (supplied) into the AC power outlet.
1 – 5. BINDING CABLES
The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamp.
Click on the first or last page to see other PN-60TA3 (serv.man5) service manuals if exist.