LL-T2015 (serv.man2) - Sharp Monitor User Guide / Operation Manual. Page 16

1.Turn on the main power of the monitor.

- When switching the main power switch on and

off, always wait for an interval of at least 5
seconds. Rapid switching may result in
malfunction.

2. Press the monitor's power button.

The power LED will light up orange.

3.Turn on the computer.

ON

When a signal is input from the computer, the
power LED lights up green, and the screen is
displayed. (After power is turned on, it may take
a little time until the screen is displayed.)
- If the input terminal to which the computer is

connected has not been selected, the screen
will not be displayed. If necessary, perform
input terminal switching. (right column)

Notes:
- When using an analog signal, perform an

automatic screen adjustment under the following
conditions (p.20):
- Using the monitor for the first time.
- After having changed the system settings

during use.

- Depending on the type of computer or OS, you

may need to install the monitor set-up
information on your system. (p.33)

- When connecting to a notebook, if the notebook

computer's screen is set to display at the same
time, the MS-DOS screen may not display
properly. In this case, change the setting to
display only the LCD monitor.

Turn on the
computer power
supply.

Press power button.

Use the INPUT button to switch between signal
input terminals.

Analog RGB input terminal

DVI-I input terminal

INPUT-1

<ANALOG>

INPUT-2

 <         >

INPUT

<ANALOG> or <DIGITAL>

Analog RGB input terminal

INPUT2-A

<ANALOG>

INPUT2-D

<DIGITAL>

INPUT

INPUT-1

<ANALOG>

INPUT

INPUT

Note:
- When there is no input signal, [NO SIGNAL] is

displayed.

Main power switch

DVI-I input terminal

(analog)

DVI-I input terminal

(digital)