LL-T18A1 (serv.man2) - Sharp Monitor User Guide / Operation Manual. Page 13

For analog signal
1.First perform an automatic adjustment. (p.14)
2.Perform manual adjustment where necessary.

(p.15)

The monitor can generally be used without
adjustment. If necessary perform manual adjust-
ment. (p.18)

Note:
- All adjustments will be saved even after turning

the power off.

All adjustment values can be returned to their
original ex-factory values in one command.
1. Turn off the monitor power.
2. Press the MENU button and the 

 button

simultaneously, and while doing this press the
power button (i.e. turn the power on). When [ALL
RESET] appears on the screen, the reset is
complete.

Notes:
- While [ALL RESET] is displayed, the control

buttons are disabled.

- It is not possible to reset values when the

adjustment lock is in place. Remove the
adjustment lock before attempting to operate
control buttons.

By disabling the control buttons (i.e. setting the
lock) any attempted changes to adjusted values will
be voided.
1. Turn off the monitor power.
2.While pressing the MENU button, press the

power button (i.e. turn the power on).
Continue to press the button until [ADJUSTMENT
LOCKED] appears on the screen.The lock is set
when the message is displayed.

Note:
- When the lock is in place, all buttons other than

the power button are disabled.

1. Turn off the monitor power.
2.While pressing the MENU button, press the

power button (i.e. turn the power on).
Continue to press the button until [ADJUSTMENT
UNLOCKED] appears on the screen.The lock is
released when the message is displayed.

1. Without the OSD Menu being displayed, press

the    or the   button. At the bottom of the
screen the BRIGHT bar will appear.

2. Adjust by pressing the   button (darker) or 

button (lighter).

3.Press the MENU button.

The BRIGHT bar disappers.

- The BRIGHT bar automatically disappears

several seconds after the last command.

02_LL-T18A1_gb.p65

12/12/2002, 7:27 PM

13