LL-T18A1 (serv.man2) - Sharp Monitor User Guide / Operation Manual. Page 11

- When connecting, ensure that both the monitor

and computer are switched off.

- Be careful not to overly bend the cable or add

extension cords as this could lead to a
malfunction.

Connect this device's analog signal cable to the
computer.

- Paying attention to connector direction, firmly

insert the signal cable to terminal, and then
tighten the screws at both sides.

If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.

Analog RGB terminal
(Mini D-Sub 15 pin, 3 row)

Analog signal cable

Macintosh conversion adapter

Connecting the monitor to a computer via a Digital
signal cable. (to be purchased separately)
- For digital RGB connection, the monitor has an

input for connecting to a computer with a DVI-
compatible output connector (DVI-D 24 pin or
DVI-I 29 pin) and SXGA output capability.
(Depending on the type of computer to be
connected, the display may not work correctly.)

- Paying attention to connector direction, firmly

insert the signal cable to terminal, and then
tighten the screws at both sides.

1.Connect the AC adapter to the monitor's power

terminal.

2.Attach the power cord to the AC adapter and

place the power plug into the AC outlet.

- After unplugging the AC adaptor or power cord,

be sure to wait at least 10 seconds before
plugging in again. If you put the plug back in
immediately after unplugging, damage may be
caused and the screen malfunction or not
display.

Digital signal cable

Digital RGB output
terminal (DVI-D 24
pin or DVI-I 29 pin)

DVI-D input terminal
(DVI-D24 pin)

AC adapter

Power terminal

Power cord

AC outlet

02_LL-T18A1_gb.p65

12/12/2002, 7:27 PM

11