Read Sharp LL-T17D3 (serv.man10) Service Manual online
LL-T17D3-H/B
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 3
1-7. Instructions for attaching a VESA compliant arm
An arm or stand based on the VESA standard (commercially available)
can be attached to the monitor.
Procurement of the arm or stand is at the customer's discretion.
Procurement of the arm or stand is at the customer's discretion.
When choosing the arm to be installed please take note of the following
points.
• The arm should be compatible with the VESA standard, and there
must be a gap of 100mm x 100mm between the screw holes on the
section to be attached.
section to be attached.
• The arm must not fall off or break off after being attached to the
monitor.
1.
Ensure that both the monitor and computer are switched off.
2.
Unplug the power cord from the AC outlet.
3.
Remove the analog signal and audio cables from the computer.
4.
Fold back the display section.
1) If carrying out adjustments to the monitor, place it upright.
2) While pressing the rear lock disable button, gently fold back the
monitor.
• Be careful not to allow your fingers to be pinched.
• Do not overly bend the cable or add extension cords as this could
lead to malfunction.
5.
Being careful not to damage the monitor, spread out a soft cloth and
lay the monitor on it display-side down.
6. Attach the arm to the monitor with four screws.
Note: The screws used to attach the arm should be M4 screws with a
length of 7 mm ~ 10 mm protruding from the surface to be
attached.
attached.
Using different screws could cause the monitor to fall of or to be
internally damaged.
7. Connect the signal and audio cables and power cord.
Lock disable button
Screw used to attach arm
Arm
Arm
Part of monitor to which arm is
attached
attached
7 - 10mm
Click on the first or last page to see other LL-T17D3 (serv.man10) service manuals if exist.