LL-T1610W (serv.man3). Chapter 2 Connection, Adjustment, Operation Functions - Sharp Monitor Service Manual (repair manual). Page 10

The input mode can be set. (

 buttons)

VESA : VESA mode
MAC : Power Macintosh mode

You can specify the horizontal resolution of a 400-line screen when
using US text, etc. (

 buttons)

640 : 640 x 400 dot mode 
720 : 720 x 400 dot mode (US text etc.)

Note: As the resolution input for other than 400 lines is done auto-

matically, there is no need to set it.

For display modes of less than 1280 x 1024 pixels, the display can be
expanded if desired. (

 buttons)

OFF: Expansion off

ON1: Using the fixed aspect ratio, the entire screen is enlarged.

ON2: The entire screen is enlarged.

Note: If a resolution of 1280 x 1024 pixels cannot be achieved even

after expansion is attempted, the screen’s perimeter will dis-
play black. (This is not a malfunction.) 

If [EXPAND] is set on [ON1] or [ON2], the sharpness of the image
can be adjusted. (

 buttons)

Note: If [EXPAND] is set on [OFF], [SCALING] cannot be adjusted.

If this is set on [OFF], the original color scheme of the LCD monitor
will be displayed. If this is set on [ON], the colors of will be corrected
according to the computer image. (

 buttons)

Note: To set [COLOR MODE] to [ON], set the [WHITE BALANCE] to

[STD].

Carry out the commands without the On Screen Display (OSD) Menu
displayed. If the OSD Menu is displayed, press the MENU button
(several times may be required) and begin when the OSD Menu has
disappeared.

1. Without the OSD Menu being displayed, push the   or the 

button.
The [BRIGHT] bar will be displayed on the screen.

2. Adjust by pressing the   button (darker) or   button (lighter).

Note: The BRIGHT bar automatically disappears several seconds

after the last command.

Lightly holding both sides of the monitor, adjust it to a suitable viewing
angle.

Pressure from hands on the LCD panel could cause damage.

An arm based on the VESA standard can be attached to the monitor.
The arm must be purchased separately.

When choosing the arm to be installed please take note of the follow-
ing points.

•

The arm should be compatible with the VESA standard, and there
must be a gap of  75mm x 75mm between the screw holes on the
section to be attached.

•

The arm must not fall off or break off after being attached to the
monitor.

Be careful not to cut or jam your fingers.

Note: Do not bend the signal cable or the AC adapter cable nor

place weight on them. Doing so could lead to damage.

1. Turn off the power switch and remove the power plug from the

power source.

2. Remove the rear cover, stand cover and adapter cover.

To remove them follow steps 1, 2, and 3 of Connecting the monitor
to a power source.

3. Remove the AC adapter from the stand.

4. Being careful not to damage the monitor, spread out a soft cloth

and lay the monitor on it display-side down.

45

45

30