Read Sharp LL-T1610W (serv.man3) Service Manual online
3. Double click on [Adj_uty.exe] to run the Adjustment Program. The
Adjustment Pattern will appear.
Notes:
•
After completing the adjustments, press the computer’s
[Esc] key to exit the Adjustment Program.
[Esc] key to exit the Adjustment Program.
•
If the floppy disk drive of your computer is not "A drive",
please read the below substituting the floppy disk drive
you are using in place of "A drive" or "A".
please read the below substituting the floppy disk drive
you are using in place of "A drive" or "A".
•
If your computer’s display mode is set to 65K colors, you
may see the different color levels in each color pattern or
the gray scale may look colored. (This is due to the speci-
fication of the input signal and is not a malfunction.)
may see the different color levels in each color pattern or
the gray scale may look colored. (This is due to the speci-
fication of the input signal and is not a malfunction.)
(2) MANUAL SCREEN ADJUSTMENT
Adjustments can be made using On Screen Display (OSD) Menu
provided.
provided.
1. Display an image that makes the entire screen very bright. If using
Windows, you can open and use the Adjustment Pattern on the
accompanying Utility Disk.
accompanying Utility Disk.
2. Press the MENU button.
The ADJUSTMENT Menu will be displayed.
At this point relevant menu options can be adjusted. Each time the
MENU button is pressed the next menu is selected. (ADJUST-
MENT
MENU button is pressed the next menu is selected. (ADJUST-
MENT
GAIN CONTROL
WHITE BALANCE
MODE SE-
LECT OSD Menu disappears)
Notes:
•
The OSD Menu automatically disappears approximately
30 seconds after the last command.
30 seconds after the last command.
•
This explanation is based on using the Adjustment Pattern
(for Windows) to make adjustments.
(for Windows) to make adjustments.
ADJUSTMENT Menu
MANUAL:Individual menu options are manually adjusted.
AUTO:
Every menu option is automatically adjusted.
Notes:
•
Press the button to select [AUTO].
•
To choose a menu option : SELECT button
•
To go to the next menu : MENU button
CLOCK
The figure below demonstrates how to adjust so that vertical flicker
noise is not emitted. (
noise is not emitted. (
buttons)
PHASE
The figure below demonstrates how to adjust so that horizontal flicker
noise is not emitted. (
noise is not emitted. (
buttons)
Note: Adjustments to PHASE should be made only after CLOCK has
been correctly set.
Adjustment pattern
Vertical flicker noise
Horizontal flicker noise
Click on the first or last page to see other LL-T1610W (serv.man3) service manuals if exist.