Read Sharp LL-T1512W (serv.man7) Service Manual online
LL-T1512W
2 – 2
• When you use a Digital signal cable (to be purchased separately),
plug the Digital signal cable’s connector into DVI-D input connector
and fix with screws each side.
• When you use only the digital signal cable, it allows you to remove
the analog signal cable. (Disconnect by loosening the screws each
side.)
6. Close the cover (c).
Slide the cover (c) ahead slowly until the hooks each side reach to
catchers. Be careful not to put the cables between any others.
catchers. Be careful not to put the cables between any others.
7. Close the cover (b).
1) Run cable through the opening of the cover, and insert the
hooks each side into projection.
2) Push slowly the upper side of the cover until the hooks click
into place.
8. Close
the
cover
(a).
1) Insert the three hooks into the slit.
2) Push slowly both sides of the cover until the three hooks click
into place.
9. Connect the AC cord to the AC adapter inlet, and plug into AC out-
let.
Note: When you remove the cover (b), you must disconnect the AC
cord from AC adapter inlet. It is impossible to remove the cover
(b) when power cord is connected to AC adapter.
(b) when power cord is connected to AC adapter.
(When you are faced with an AC cord tightened into AC
adapter, please pull it off slowly and carefully.)
Digital signal cable (to be purchased separately)
Click on the first or last page to see other LL-T1512W (serv.man7) service manuals if exist.