Read Sharp LL-171A Service Manual online
LL-171A-W/B/LL-171G-W/B
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 8
5-10. If you want to load the program onto another monitor,
repeat the procedure from step 5-6.
6. SETUP TO BE PERFORMED AFTER LOADING
THE PROGRAM
Turn off the main power supply and then turn it on.
If the LEDs (green and orange) come on, press the [POWER] button to
turn them off.
6-1. Set the language default value for [ENGLISH].
6-1-1. Turn on the AC power supply.
6-1-2. Hold down the [MENU] + [
1
] + [
3
] buttons and press the
[POWER] button.
6-1-3. An OSD "OSD DEFAULT LANGUAGE" appears.
Select [ENGLISH].
6-1-4. Press the [MENU] button to close the OSD.
6-2. [Execute All] reset.
Hold down the [MENU] + [MODE] buttons and press the [POWER] button.
All reset is executed and the [ENGLISH] OSD is displayed.
All reset is executed and the [ENGLISH] OSD is displayed.
6-3. Check the version
Hold down the [MENU] + [
3
] button and press the [POWER] button.
Either of the following notifications appears. Check the model name,
version, date and checksum.
Press the [MENU] button to close the OSD.
6-4. Press the [POWER] button to turn off the software
power supply.
6-5. Turn off the AC power supply using the AC power
supply switch.
■
CONNECTION OF FIRMWARE EDID WRITING BOARD
MODEL NAME
VERSION
DATE
CHECKSUM
VERSION
DATE
CHECKSUM
V-sync
H-sync
H-sync
: 171AE
: 1.002
: 11/29/2003
: 565B
: 1.002
: 11/29/2003
: 565B
: 60Hz
: 48kHz
: 48kHz
MODEL NAME
VERSION
DATE
CHECKSUM
VERSION
DATE
CHECKSUM
V-sync
H-sync
H-sync
: 171GE
: 1.001
: 12/11/2003
: EA58
: 1.001
: 12/11/2003
: EA58
: 60Hz
: 48kHz
: 48kHz
ɡ
LL-171A
ɡ
LL-171G
USB cable
ġ
ġ
USB
Connected to PC
ġ
(Case of X1049MP-27)
Connect to the COM1
port of the PC
port of the PC
RS-232C (9-pin D-sub)
cross cable
cross cable
Use X1049MP-27.
DVI-D
connector
RGB
connector
Serial connector
Parallel connector
Board
RGB cable
RGB
terminal
Rear part of the
LL-171 series
(not necessary for
firmware writing)
firmware writing)
Connect to the USB port of the PC (5V)
SW1 : Parallel (EDID)
Serial (PROGRAM)
SW2 :
AUTO
MANUAL
SW3 :
1502A
T1620
SW4 :
1502A
T1620
Dip switch direction of X1049MP-27:
SW1 firmware is at the serial side.
SW1 firmware is at the serial side.
Click on the first or last page to see other LL-171A service manuals if exist.