Home fuse blows when power cord is plugged into wall receptacle.
Fuse 20A blows when power cord is plugged into wall receptacle
PRESS STOP" does not appear in display when power cord is first
plugged into wall receptacle.
Display does not operate properly when STOP/CLEAR key is touched.
(The time of day should appear on the display with beep sound.)
Oven lamp does not light with door opened.
Oven lamp does not light in cook cycle. (It light when door is opened).
Cooking cycle runs 1 minute then shuts down.
Oven lamp light, but turntable motor does not operate.
Turntable motor operates normally but cooling fan motor does not
Oven does not go into a cook cycle, when START key is touched.
Low or no power is produced during microwave cooking (The food is
heated incompletely or not heated at all)
Extremely uneven heating is produced in oven load (food).
Function of variable cooking does not operate properly except HIGH
Oven does not go into cook cycle when START pad is touched.
Heating elements do not heat.
Temperature in the oven cavity is lower or higher than preset.
Convection cycle runs for 10 minutes then shuts down.
Convection motor does not operate of all or properly.
HIGH VOLTAGE TRANSFORMER
H.V. RECTIFIER ASSEMBLY
HIGH VOLTAGE CAPACITOR
SECONDARY INTERLOCK SWITCH
3RD. LATCH SWITCH
DOOR SENSING SWITCH
HIGH VOLTAGE FUSE
MAGNETRON TEMPERATURE FUSE
THERMAL CUT-OUT (TOP)
TOP HEATING ELEMENT
TOUCH CONTROL PANEL
FUSE1 ON PWB.
SOLID-STATE RELAY (TOP)
SOLID-STATE RELAY (SIDE)
FAN MOTOR (MAGNETRON)
SHORTED IN POWER CORD
NO POWER AT OUTLET
THERMAL CUT OUT (SIDE)
SIDE HEATING ELEMENT
(HIGH VOLTAGE TRANSFORMER)
CONVECTION MOTOR CAPACITOR