DOS HOSPITALITY (serv.man31). Upgrade to Ver 4.2.085 (Documentation) - Sharp EPOS Driver / Update. Page 20

15

Control POS and then connect it to a PC using an APLD Cable. Then using
WMFLASH.BAT for Flash/Ram POS and WMHDD.BAT for Hard Disk POS follow the
Instructions on the PC screen. When this has been completed the POS is ready for
Waitermate Connection. It is only necessary to carry this out at the Control POS.

In order to set the Control POS carry out the following after Version 4 Upgrade.

1.

Copy the Waitermate Installation file WAITERM.EXE into a New folder on the PC
and Execute it, then connect the PC to the POS using the APLD cable and enter
WMFLASH of WMHDD on the PC and follow the On-Screen Instructions.

2.

After completion re-start the POS and follow the Instructions below.

1.

To set the Waitermate Control POS it is only necessary to enable it in C:\RINCS.CFG
as follows :-

[GCNET]
REM V4********************WAITERMATE PROGRAMMING START******************

REM ============PORT SETTING============

REM To set the Port that the Waitermate Base Station is connected to
REM remove the REM line below and set n= Com Port Number

REM ======WAITERMATE PRINT STATION======

REM To set which POS Terminal to send Waitermate Receipts and Bills
REM remove the REM statement below and set n= POS Terminal Number and
REM x= to the Waitermate Number (e.g To set Waitermate 1 to print at POS
REM Terminal 3 WMPRINT1=3)

REM *********************WAITERMATE PROGRAMMING END*********************

The two settings are :-

Waitermate=n Where n is the Serial port that the Waitermate Home Base is connected (N.B
This should be Port 1 or 2)

WMPRINTx=n Where x is the Waitermate Number and n is the POS Terminal Number that
sets the Receipt/Bill printer that will be used to print from the Waitermate set in x. This is to
enable different Waitermates to print at different machines, e.g if WMPRINT2=4 was set,
Waitermate 2 would print on the Receipt/Bill printer that was set on Terminal 4 Till
parameters.