DV-RW360H (serv.man8). Pages 26-50 - Sharp DVD User Guide / Operation Manual. Page 7

32

EN

Press [ENTER] when all informa-
tion required is entered.
Your programme setting is 
stored.
•  To set another programme, 

repeat steps 2 to 8.

•  To exit, press [TIMER PROG.].
•  If the recording times of two 

or more programmes overlap, 
“Overlap” and overlapped 
programme numbers are 
displayed. (See pages 33-34.)

Press [T-SET].
The 

 icon will appear on the 

front panel display and the unit 
enters to the timer-standby 
mode.

MENU LIST

TOP MENU

STOP

PLAY

FWD

REV

SKIP

PROG.

CLEAR/C-RESET

VCR

REC/OTR

DVD

REC/OTR

PQRS

TUV

WXYZ

GHI

JKL

MNO

.@/:

ABC

DEF

SPACE

DISPLAY

ENTER

ZOOM

REC MODE

VCR

RAPID PLAY

DVD

CM SKIP

SETUP

T-SET

    OPEN/CLOSE

EJECT

TIMER PROG.

DUBBING

RETURN

OPERATE

You can set the unit to record up 
to 8 programmes, up to a month 
in advance. Daily or weekly 
programme recordings are also 
available.
•  Be sure to set the clock before 

entering a timer programming.

In stop mode, press 
[TIMER PROG.].
Timer Programming list will appear.

Select a programme that is not 
set using [Cursor K / L], then 
press [ENTER].

Enter the date using [Cursor 
K

 / L], then press [Cursor B].

Each time you press [Cursor L] 
at the current date, the timer 
recording date will change as 
follows.

Enter the time to start and to 
end using [Cursor K / L], then 
press [Cursor B].

Select the channel number to 
record using [Cursor K / L], 
then press [Cursor B].

To record from the external input, 
select “AV1”, “AV2”, or “AV3”.

Select the recording media 
(“DVD” or “VCR”) using [Cursor 
K

 / L], then press [Cursor B].

Select the recording mode using 
[Cursor K / L]. (See page 24.)

•  If you have not set the clock, the clock setting window will appear 

instead of the Timer Programming list. Continue from step 4 in “Clock 
Setting” on page 22 before programming the timer.

•  Press [Cursor { / B] to move the cursor in the Timer Programming list.
•  If a basic recording or One-touch Timer Recording is in progress on 

one component (e.g. VCR) and the timer recording set for the other 
component (e.g. DVD) is about to begin, the unit automatically 
switches to the programmed channel for timer recording 2 minutes 
before the programmed starting time, and the recording in progress 
(for VCR) will be cancelled UNLESS their recording channels are the 
same. If their recording channels are the same, the timer recording 
will start without cancelling the recording currently in progress. In this 
case, the recording of the same channel will be made on both DVD 
and VCR.

•  Cancel the timer-standby mode by pressing [T-SET] before operation 

for either DVD or VCR. When finished operating, press [T-SET] to 
resume the timer-standby mode.

•  In the timer-standby mode, you can turn on the power and use the 

component (VCR or DVD) which is not currently timer-programmed.