Read Sharp DV-NC65H (serv.man29) User Guide / Operation Manual online
71
www.sharp.co.uk/support
When you load a video cassette into the Unit, the Unit can calculate
approximately the amount of video tape remaining in hours and
minutes. This is useful in determining whether or not there is suffi-
cient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is
calculated automatically. To display the amount of video tape
remaining:
approximately the amount of video tape remaining in hours and
minutes. This is useful in determining whether or not there is suffi-
cient tape left to make a recording.
When a video tape is playing, the amount of tape remaining is
calculated automatically. To display the amount of video tape
remaining:
1
Load the video cassette into the Unit.
2
Press DISPLAY as many times as necessary until “R” appears
on the VCR Front Panel display. The tape will wind forward for a
few seconds and then return to its original position. The tape
remaining will be shown on the VCR Front Panel display in hours
and minutes. By pressing TAPE SPEED on the Remote the
remaining time will change between standard play, long play and
extended play.
on the VCR Front Panel display. The tape will wind forward for a
few seconds and then return to its original position. The tape
remaining will be shown on the VCR Front Panel display in hours
and minutes. By pressing TAPE SPEED on the Remote the
remaining time will change between standard play, long play and
extended play.
• If the TAPE REMAINING function is interrupted, the remaining time will
not be displayed.
• If less than 5 minutes of tape remains the display will flash.
• When you start recording or playback, the VCR will begin the
• When you start recording or playback, the VCR will begin the
computation. However, this may take some time. When the
computation is completed, the tape remaining will be shown on the
OSD and VCR display for 5 seconds.
computation is completed, the tape remaining will be shown on the
OSD and VCR display for 5 seconds.
• If the “REM” mode is selected with MODE OSD or DISPLAY and the
VCR is in Stop mode, the tape will automatically fast forward or rewind
for a few seconds and then the VCR will begin computing the amount
of tape remaining.
for a few seconds and then the VCR will begin computing the amount
of tape remaining.
• During computation, REC will not function and pressing STOP,
PLAY/X2 or other buttons will interrupt the computation.
• Setting the DPSS or ZERO BACK function during computation may
cancel it.
• The indicated length of tape remaining is only an approximate guide.
• This function may not work properly for video tapes other than E-60,
• This function may not work properly for video tapes other than E-60,
E-90, E-180 and E-240.
• The length of tape remaining during fast forward or rewind may be
indicated as greater than it actually is.
• When and
S
tapes are used with a cassette adapter, the
indication may not be correct.
Tape Remaining
/
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
VIDEO Plus+
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ANGLE
CLEAR
RETURN
REV
FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVD
AM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
PLAY
STOP
SLOW
CH
VCR
DVD
SKIP
DPSS
AUDIO
OUTPUT
RRMCGA069WJSA
C
C
DVNC65H071_072.pm6
30/8/02, 11:52 am
71
Click on the first or last page to see other DV-NC65H (serv.man29) service manuals if exist.