DV-NC65H (serv.man13). Adjustment, replacement and assembly of mechanical units - Sharp DVD Service Manual (repair manual). Page 8

• Reassembly (Supply reel disk)
1. Clean the reel disk shaft and apply grease (SC-141) to

it.

2. Match the phases of reel disk and reel relay gear, and set

the new reel disk.

3. After checking the reel disk height, wind the tension

band ass'y around the reel disk.

4. Assemble the Supply main brake ass'y.

Notes:
1. When installing the reel disk, take due care so that the

tension band ass'y is not deformed and grease does no
adhere.

2. Do not damage the Supply main brake ass'y. Be careful

so that grease does not adhere to the brake surface.

• Reassembly (Take-up reel disk)
1. Clean the reel disk shaft and apply grease (SC-141) to

it.

2. Align the phase of the reel disk to that of the reel relay

gear and to install a new take-up reel disk onto the shaft.

3. Check the reel disk height and reassemble the take-up

main brake ass'y.

Notes:
1. Take care so that the Take-up main brake ass'y is not

damaged. Take care so that grease does not adhere the
brake surface.

2. After reassembly, check the video search rewind back

tension (see 8-12), and check the brake torque (see 8-
16 ).

Take-up reel disk

Supply reel disk

Ten

Tension arm ass'y

Supply main brake

Tension band 
ass'y

Take-up main brake ass'y

• Removal
1. Remove the cassette control housing assembly.
2. Remove the Supply/Take-up main brake ass'y.
3. Lift the tension band on the reel disk side, remove tension

band from the tension arm ass'y.
(Do not deform it excessively.)

4. Remove the reel disk.

Note:
Take care so that the tension band ass'y and main brake
ass'y are not deformed.

Note:
1. Check that the reel disk is lower than part A but higher

than part B. If the height is not correct, readjust the reel
disk height by changing the poly-slider washer under the
reel disk.

2. Whenever replacing the reel disk, perform the height

checking and adjustment.

• Height checking and adjustment
1. Set the master plane with due care so that it does not

contact the drum.

2. When putting the master plane, shift the reverse guide

a little in the loading direction. Care must be taken since
excessive shift results in damage.

Supply reel disk

Take-up reel disk

Cassette lock
release shaft

Master plane

A

B

Master plane

Reel disk height
adjusting jig

Mechanism chassis

Reel disk

10 

± 0.2mm

Reel disk