XL-HF401PH (serv.man3) - Sharp Audio User Guide / Operation Manual. Page 27

12/3/30

HF-401PH_OM_EN_UK.fm

Remove the iPod, iPhone, iPad, USB memory device and disc from
the unit. Then, set the unit to the power stand-by mode. Carrying the
unit with iPod, iPhone, iPad or USB memory device left connected
or discs left inside might damage the unit.

Compact discs are fairly resistant to damage, however mistracking can occur
due to an accumulation of dirt on the disc surface. Follow the guidelines below
for maximum enjoyment from your CD collection and player.

● Do not write on either side of the disc, particularly the non-label side

from which signals are read. Do not mark this surface.

● Keep your discs away from direct sunlight, heat, and excessive

moisture.

● Always hold the CDs by the edges. Fingerprints, dirt, or water on the

CDs can cause noise or mistracking. If a CD is dirty or does not play
properly, clean it with a soft, dry cloth, wiping straight out from the
centre, along the radius.

Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.

● Do not use chemicals for cleaning (petrol, paint thinner,

etc.). It may damage the cabinet.

● Do not apply oil to the inside of the unit. It may cause malfunctions.

Poor performance during CD playback (skipping or
jumping) can be caused by a dirty or contaminated CD
laser pick up lens. If this happens then the use of a
commercially available CD lens cleaning disc may restore
normal operation. Contact your supplier or local CD
software dealer to obtain CD lens cleaning discs. Ensure all
included instructions/documentation are carefully followed.

As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures  indicated are nominal values of production units. There
may be some deviations from these values in individual units.

■ Before transporting the unit

■ Care of compact discs

■ Cleaning the cabinet

■ Cleaning the CD pickup lens

■ General

AC 220 - 240 V ~ 50/60 Hz

Power on: 40 W
Power stand-by: 0.4 W (*)

Width: 215 mm (8 - 1/2")
Height: 96 mm (3 - 4/5")

136 mm (5 - 2/5") (with Wi-Fi 

aerial upright)

Depth: 335 mm (13 - 1/5")

2.8 kg (6.2 lbs.)

( * ) This power consumption value is obtained when the

Network Stand-by (demonstration) mode is cancelled in
the power stand-by mode. Refer to page 6 to cancel the
Network Stand-by (demonstration) mode.

■ Amplifier

RMS: 100 W (50 W + 50 W) (10% T.H.D.)
RMS: 66 W (33 W + 33 W) (1% T.H.D.)

Speakers: 4 ohms, 20Hz - 20kHz
Subwoofer Pre-out (audio signal): 
200 mV/10 k ohms at 70 Hz
Video output: 1 Vp-p
Headphones: 16 ohms 
(recommended: 32 ohms)

Audio In (Audio signal):
500 mV/47 k ohms
Line in (Analogue input):
500 mV/47 k ohms

■ CD player

Single disc multi-play compact disc player

Non-contact, 3-beam
semiconductor laser pickup

Multi bit D/A converter

Frequency response 20 - 20,000 Hz
Dynamic range

90 dB (1 kHz)

■ USB (MP3 / WMA)

● Complies with USB 1.1 (Full 

Speed)/2.0 Mass Storage 
Class.

● Support Bulk only and CBI 

protocol.

● MPEG 1 Layer 3

● WMA (Non DRM)

● MP3 (32 ~ 320 kbps)

● WMA (64 ~ 160 kbps)

● Maximum total number of 

MP3/WMA files is 65025.

● Maximum total number of 

folders is 999 INCLUSIVE of 
root directory.

● The ID3TAG information 

supported are TITLE, ARTIST 
and ALBUM only.

● Supports ID3TAG version 1 

and version 2.

● Support USB devices with 

Microsoft Windows/DOS/FAT 
12/FAT 16/ FAT 32.

● 2 kbyte block length for sector.

■ Tuner

FM: 87.5 - 108.0 MHz

40 (FM station)

■ Speaker

2-way type speaker system
2.5 cm (1") Dome-Tweeter
12 cm (4-3/4") Woofer

100 W

50 W

4 ohms

Width: 148 mm (5-13/16")
Height: 262 mm (10-5/16")
Depth: 203.5 mm (8")

2.5 kg (5.4 lbs.)/each