Read Sharp SD-EX200 User Guide / Operation Manual online
27
SD-EX200H_uk.fm
03/2/18
SD-EX200H
Ad
v
a
nced
F
e
atures
- Enha
nc
ing y
our
s
y
s
te
m
-
Enhancing your system
"
The connection lead is not included. Purchase a commercially available lead as
shown below.
shown below.
"
Before connecting external units, set this unit to the power stand-by mode and turn
off the power to the external units.
off the power to the external units.
!
Listening to the playback sounds from
VCR, DVD, etc.
VCR, DVD, etc.
Note:
To prevent hum interference, place this unit away from a television.
!
To record CD signals on MDs
The digital signal from this unit can be recorded by MiniDisc recorders, etc.
Notes:
"
When using the optical digital socket, remove the cap first. After using the socket,
replace the cap.
replace the cap.
"
Only CD signals can be output.
!
Headphones
"
Before plugging in or unplugging the headphones, reduce the volume.
"
Be sure your headphones have a 3.5 mm (1/8") diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
"
Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME buttons.
volume using the VOLUME buttons.
VCR, DVD etc.
MD recorder
To the optical
line input socket
line input socket
Connection
cable for digital
recording
(not supplied)
cable for digital
recording
(not supplied)
(CD only)
To the line
output sockets
output sockets
RCA lead
(not supplied)
(not supplied)
White
Red
Audio signal
Audio signal
1 Use a connection lead to connect the VCR, DVD, etc. to the AUX INPUT sockets.
When using video equipment, connect the audio output to this unit and the video
output to a television.
output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUX button.
4 Play the VCR, DVD, etc.
3 Press the AUX button.
4 Play the VCR, DVD, etc.
1 Open the left side cover and then remove the DIGITAL OUT socket cover.
2 Close the left side cover (see page 11).
3 Use a connection cable for digital recording to connect the unit to the OPTICAL IN
2 Close the left side cover (see page 11).
3 Use a connection cable for digital recording to connect the unit to the OPTICAL IN
socket of a MiniDisc recorder, etc.
4 Press the ON/STAND-BY button to turn the power on.
5 Put the MiniDisc recorder, etc. in the recording mode.
6 Play a CD on this unit.
5 Put the MiniDisc recorder, etc. in the recording mode.
6 Play a CD on this unit.
Headphones
Click on the first or last page to see other SD-EX200 service manuals if exist.