Read Sharp SD-EX200 User Guide / Operation Manual online
MODEL
SD-EX200H
1-BIT DIGITAL AUDIO SYSTEM
OPERATION MANUAL
2
SD-EX200H_uk.fm
03/2/18
SD-EX200H
Im
por
tant Instruction
-
Spec
ial N
o
te
s -
Special Notes
NOTES FOR USERS IN THE U.K. AND IRELAND
The mains lead of this product is fitted with a non-rewireable (moulded)
plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI
or ASTA approved BS 1362 fuse marked or and of the same rating as
above, which is also indicated on the pin face of the plug must be used.
plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI
or ASTA approved BS 1362 fuse marked or and of the same rating as
above, which is also indicated on the pin face of the plug must be used.
Always refit the fuse cover after replacing the fuse. Never use the plug
without the fuse cover fitted.
without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being compat-
ible with the plug supplied, cut-off the mains plug and fit an appropriate
type.
ible with the plug supplied, cut-off the mains plug and fit an appropriate
type.
DANGER:
The fuse from the cut-off plug should be removed and the cut-off plug
destroyed immediately and disposed of in a safe manner.
The fuse from the cut-off plug should be removed and the cut-off plug
destroyed immediately and disposed of in a safe manner.
Under no circumstances should the cut-off plug be inserted elsewhere
into a 13A socket outlet as a serious electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:
into a 13A socket outlet as a serious electric shock may occur.
To fit an appropriate plug to the mains lead, follow the instructions below:
IMPORTANT:
The wires in the mains lead are coloured in accordance with the following
code:
Blue
The wires in the mains lead are coloured in accordance with the following
code:
Blue
: Neutral
Brown : Live
As the colours of the wires in the mains lead of this product may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured blue must be connected to the plug terminal
which is marked N or coloured black.
The wire which is coloured brown must be connected to the plug termi-
nal which is marked L or coloured red.
Ensure that neither the brown nor the blue wire is connected to the earth
terminal in your three pin plug.
terminal in your three pin plug.
Before replacing the plug cover, make sure that:
If the new fitted plug contains a fuse, its value is the same as that
removed from the cut-off plug.
removed from the cut-off plug.
The cord grip is clamped over the sheath of the mains lead and not
simply over the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SERVICE INFORMATION
In the unlikely event of your equipment requiring repair, please contact
the dealer or supplier from whom it was purchased. Where this is not
possible, please visit our web-site www.sharp.co.uk/customersupport.
Customers without internet access may telephone 08705 274277 dur-
ing office hours (or (01) 676 0648 if telephoning from lreland).
Please note; all calls will be charged at local rate.
In the unlikely event of your equipment requiring repair, please contact
the dealer or supplier from whom it was purchased. Where this is not
possible, please visit our web-site www.sharp.co.uk/customersupport.
Customers without internet access may telephone 08705 274277 dur-
ing office hours (or (01) 676 0648 if telephoning from lreland).
Please note; all calls will be charged at local rate.
Certain replacement parts and accessories may be obtained from our
main parts distributor.
main parts distributor.
WILLOW VALE ELECTRONICS LTD.
0121 766 5414
In the unlikely event of this equipment requiring repair during the guaran-
tee period, you will need to provide proof of the date of purchase to the
repairing company.
Please keep your invoice or receipt, which is supplied at the time of pur-
chase.
tee period, you will need to provide proof of the date of purchase to the
repairing company.
Please keep your invoice or receipt, which is supplied at the time of pur-
chase.
0301
3
SD-EX200H_uk.fm
03/2/18
SD-EX200H
Im
por
tant Instruction
- S
p
ec
ial Not
e
s
/ Cont
ent
s
-
WARNING
!
When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still
present inside the unit. When the ON/STAND-BY button is set at STAND-BY posi-
tion, the unit may be brought into operation by the timer mode or remote control.
present inside the unit. When the ON/STAND-BY button is set at STAND-BY posi-
tion, the unit may be brought into operation by the timer mode or remote control.
!
This unit contains no user serviceable parts. Never remove covers unless qualified
to do so. This unit contains dangerous voltages, always remove mains plug from
the socket before any service operation and when not in use for a long period.
to do so. This unit contains dangerous voltages, always remove mains plug from
the socket before any service operation and when not in use for a long period.
!
To prevent fire or shock hazard, do not expose this appliance to dripping or splash-
ing. No objects filled with liquids, such as vases, should be placed on the appara-
tus.
ing. No objects filled with liquids, such as vases, should be placed on the appara-
tus.
CAUTION
!
This product is classified as a CLASS 1 LASER product.
!
Use of controls, adjustments or performance of procedures other than those spec-
ified herein may result in hazardous radiation exposure.
ified herein may result in hazardous radiation exposure.
NOTES
This equipment complies with the requirements of Directives 89/336/EEC and 73/23/
EEC as amended by 93/68/EEC.
EEC as amended by 93/68/EEC.
Contents
Page
"
General Information
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Controls and indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 8
Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Controls and indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 8
"
Preparation for Use
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
System connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 - 11
General control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Setting the clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
System connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 - 11
General control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Setting the clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
"
CD Playback
Listening to a CD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 - 15
Advanced CD Playback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 - 17
Advanced CD Playback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 - 17
"
Radio
Listening to the radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 - 19
"
RDS Radio
Using the Radio Data System (RDS) . . . . . . . . . . . . . . . . . . . . . . 20 - 23
"
Advanced Features
Timer and sleep operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 - 26
Enhancing your system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Enhancing your system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
"
References
Troubleshooting chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 - 29
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
Error messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
Error messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
TERMS OF GUARANTEE . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back cover
As the laser beam used in this compact disc player is harmful to the eyes, do not
attempt to disassemble the cabinet. Refer servicing to qualified personnel only.
attempt to disassemble the cabinet. Refer servicing to qualified personnel only.
Laser Diode Properties
Material: GaAIAs
Wavelength: 780 nm
Emission Duration: continuous
Laser Output: max. 0.6 mW
Wavelength: 780 nm
Emission Duration: continuous
Laser Output: max. 0.6 mW
If you require any advice or assistance regarding your Sharp product,
please visit our web-site www.sharp.co.uk/customersupport. Customers
without Internet access may telephone 08705 274277 during office hours
(or (01) 676 0648 if telephoning from Ireland).
please visit our web-site www.sharp.co.uk/customersupport. Customers
without Internet access may telephone 08705 274277 during office hours
(or (01) 676 0648 if telephoning from Ireland).
4
SD-EX200H_uk.fm
03/2/18
SD-EX200H
Gen
e
ral
In
fo
rmatio
n
- Intr
oduc
tion / Ac
c
e
s
s
or
ie
s
-
Introduction
Accessories
Please confirm that the following accessories are included.
Note:
Only the above accessories are included.
Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your
SHARP product.
SHARP product.
!
SD-EX200H 1-Bit Digital Audio System consisting of SD-EX200H (main unit) and CP-EX200H (speaker system).
Remote control 1
"AA" size battery (UM/SUM-3, R6,
HP-7 or similar) 2
Speaker wire 2
FM aerial 1
AM loop aerial 1
