Read Sharp SD-EX200 User Guide / Operation Manual online
19
SD-EX200H_uk.fm
03/2/18
SD-EX200H
Ra
dio
- Lis
te
n
ing t
o
the
r
a
dio -
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
"
"
" will appear when an FM broadcast is in stereo.
"
If the FM reception is weak, press the TUNER (BAND) button to extinguish the
"ST" indicator. The reception changes to monaural, and the sound becomes
clearer.
"ST" indicator. The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
!
Memorising a station
You can store 40 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
ton. (Preset tuning)
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or if the AC power lead is disconnected.
a power failure or if the AC power lead is disconnected.
!
To recall a memorised station
This may be operated only with the remote control.
FM stereo mode indicator
FM stereo receiving indicator
1
Perform steps 1 - 3 in "Manual or Auto tuning" on page 18.
2
Press the ENTER button to enter the preset tuning saving mode.
3
Within 5 seconds, press the TUNER
PRESET ( or ) button to select the
preset channel number.
PRESET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4
Within 5 seconds, press the ENTER
button to store that station in memo-
ry.
button to store that station in memo-
ry.
If the preset number indicator goes out before the station is memorised, repeat
the operation from step 2.
the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
be erased.
To select a preset station with the TUNER PRESET buttons:
Press the TUNER PRESET ( or ) button to select the desired station.
To select a preset station with the direct buttons:
Station 1 - 10:
press the corresponding number ("1" - "10/0").
Station 11 - 40:
press the " 10" button followed by the two-digit number.
For example, to choose 28
1 Press the " 10" button.
2 Press the "2" button.
3 Press the "8" button.
Preset channel
Frequency and frequency band
Click on the first or last page to see other SD-EX200 service manuals if exist.