Read Sharp HT-SL70 (serv.man2) User Guide / Operation Manual online
8
2011 May 5
HT-SL70 EA361
System preparation (continued)
Caution:
●
Be very careful to prevent the sound bar [0.9 kg
(1.96 lbs)] from falling when mounting on the wall.
(1.96 lbs)] from falling when mounting on the wall.
●
Before mounting, check the wall strength. (Do not put
on the veneer plaster or whitewashed wall. The sound
bar may fall.) If unsure, consult a qualified service
technician.
on the veneer plaster or whitewashed wall. The sound
bar may fall.) If unsure, consult a qualified service
technician.
●
Mounting screws are not supplied. Use appropriate
ones.
ones.
●
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur or
the sound bar may get damaged.
the sound bar may get damaged.
●
SHARP is not responsible for accidents resulting
from improper installation.
from improper installation.
●
Do not let children dangle on the sound bar once it is
attached on the wall as it can cause damage and injury.
attached on the wall as it can cause damage and injury.
SHARP designed the sound bar so you may hang them on
the wall. Use proper screws (not supplied). See below for
size and type.
the wall. Use proper screws (not supplied). See below for
size and type.
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
Make sure all screws are fully tightened. (screws are not
supplied)
Falling prevention
Safety wires (not supplied) are useful to prevent the sound
bar from falling off the table.
bar from falling off the table.
Loop the safety wires (not supplied) into each hole as
shown and tie the safety wires to the LCD TV stand.
shown and tie the safety wires to the LCD TV stand.
■
Driving screws
■
Fixing wall mount angle
1
Fix the pattern paper to the wall in horizontal
position as below.
position as below.
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
marks on the pattern paper by using a drill.
3
Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall
surface.
using a hammer, until it is flush with the wall
surface.
3.2 mm (1/8")
9 mm (3/8")
Min. 22 mm (7/8" )
5 mm
(3/16")
(3/16")
Pattern paper
Wall surface
Wall surface
8-9 mm (3/8")
32 mm (1-1/4")
Wall surface
8-9 mm (3/8")
32 mm (1-1/4")
4
Screw the wall mount angle to the wall as shown in
the illustration. (Total screw is 4 pieces)
the illustration. (Total screw is 4 pieces)
■
Installing the sound bar
1
Align the wall mount slot at the sound bar to the
wall mount angle.
wall mount angle.
2
Slot the sound bar into the wall mount angle.
3
Fix them securely.
Wall surface
Wall mount angle
Wall mount
angle
angle
Wall
surface
Wall surface
Wall
mount
angle
mount
angle
(screws x 2)
(screws x 2)
Wall surface
Click on the first or last page to see other HT-SL70 (serv.man2) service manuals if exist.