Read Sharp HT-SB30 User Guide / Operation Manual online
E-
To turn the power on
■
Press the ON/STAND-BY button.
The STAND-BY indicator turns BLUE.
Note:
Note:
If the power does not turn on, check whether
the power lead is plugged in properly.
To set the sound bar to stand-by mode:
To set the sound bar to stand-by mode:
Press the ON/STAND-BY button again. The
STAND-BY indicator turns RED.
Volume auto fade-in
■
If you turn off and on the sound bar again,
volume will start at lower level and gradually
increase to the last set level.
Volume control
■
Sound bar operation:
Press volume up (VOLUME + ) to increase
the volume and press volume down (VOL-
UME – ) to decrease the volume.
Remote control operation:
Remote control operation:
Press the VOL + button to increase the
volume and the VOL – button to decrease
the volume. (Refer page 4, buttons number
15.)
Note:
Note:
When volume is maximum or minimum:
The SURROUND indicator: blinks 3 times
Muting
■
The volume is muted temporarily when
pressing the MUTE button on the
remote control. Press again to restore
the volume.
Surround
■
When the SURROUND button is
pressed, the SURROUND sound is
ON. (SURROUND indicator lights up
(ORANGE))
Sound Mode
■
Remote control operation:
Press the desired sound mode button
on the remote control.
The SURROUND indicator: blinks once
CINEMA (for cinema sound effect)
MUSIC
MUSIC
(for standard sound effect)
NEWS
(for news)
BYPASS (for flat sound effect)
Function
■
When the INPUT button is pressed, the
input source will change.
1 Audio In Function - the pairing
1 Audio In Function - the pairing
indicator turns off.
2 Bluetooth Function - the pairing
indicator turns blue.
Note:
The backup function will protect the
memorized function mode for a few hours
should there be a power failure or the AC
power lead becomes disconnected.
Auto power on function:
When stand-by indicator is VIOLET,
the sound bar will automatically
power ON if it detects audio signal
from connected equipment, unless
it is turned off manually (STAND-BY
indicator turns red).
Auto power off and auto detect
signal:
The sound bar will automatically
go to stand-by mode (STAND-
BY indicator turns VIOLET) if:
Audio In: no audio signal is detected
within 20 minutes.
Bluetooth: in the inactivity or pause
mode for 1 minute
●
●
General control
Click on the first or last page to see other HT-SB30 service manuals if exist.