CD-XP200H - Sharp Audio User Guide / Operation Manual. Page 33

CD-XP200H(H)E3.fm

02/02/21

CD-XP200H

Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rised SHARP dealer or service centre.

! General

 

! CD player

 

! Tuner

! Cassette deck

 

! Remote control

 

! Condensation

" The clock is not on time.

" Did a power failure occur? Reset the 

clock. (Refer to page 10.)

" When a button is pressed, the unit 

does not respond.

" Set this unit to the power stand-by mode 

and then turn it back on.

" If the unit still malfunctions, reset it. (Refer 

to page 27.)

" No sound is heard.

" Is the volume level set to "0"?
" Are the headphones connected?
" Are the speaker wires disconnected?

" Playback does not start.

" Is the disc loaded upside down?

" Playback stops in the middle or is 

not performed properly.

" Does the disc satisfy the standards?
" Is the disc distorted or scratched?

" Playback sounds are skipped, or 

stopped in the middle of a track.

" Is the unit located near excessive vibra-

tions?

" Is the disc very dirty?
" Has condensation formed inside the unit?

" Radio makes unusual noise con-

secutively.

" Is the unit placed near the TV or comput-

er?

" Is the FM aerial or AM loop aerial placed 

properly? Move the AC power lead or the 
unit away from the aerial if located near.

" Cannot record.

" Is the erase-prevention tab removed?

" Cannot record tracks with proper 

sound quality.

" Is it a normal tape? (You cannot record on 

a metal or CrO  tape.)

" Cannot erase completely.
" Sound skipping.

" Is there any slack?
" Is the tape stretched?

" Cannot hear treble.

" Are the capstans, pinch rollers, or heads 

dirty?

" Sound fluctuation.
" Cannot remove the tape.

" If a power failure occurs during playback, 

the heads remain engaged with the tape. 
Do not open the compartment forcibly. 
Wait until electricity resumes.

" The remote control does not oper-

ate.

" Is the AC power lead of the unit plugged 

in?

" Is the battery polarity respected?
" Are the batteries dead?
" Is the distance or angle incorrect?
" Does the remote control sensor receive 

strong light?

Sudden temperature changes, storage or operation in an extremely humid environ-
ment may cause condensation inside the cabinet (CD pickup, tape heads, etc.) or on 
the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens, leave the power on 
with no disc (or cassette) in the unit until normal playback is possible (about 1 hour). 
Wipe off any condensation on the transmitter with a soft cloth before operating the 
unit.