Read Panasonic TC-29P10N / TC-33P10N Service Manual online
- 9 -
Inspection of the boards [A] and [D]
1. Disconnection the degaussing coil cable and the speaker
cable clamps (2 places) and the lead clamps on the print
holder (2 places), and disconnect the degaussing coil
coupler from the board.
holder (2 places), and disconnect the degaussing coil
coupler from the board.
2. Pull out the chassis frame to the front.
3. Tilt the pulled-out chassis frame as shown in the following
figure and inspect the pattern side.
At this time, use a cloth or similar for insulation.
At this time, use a cloth or similar for insulation.
Inspection of the boards [G] and [K]
1. Pull out the chassis frame to the front, and rotate the
chassis frame as shown in following figure.
Now inspection is possible from the parts side of the
boards [G] and [K].
Now inspection is possible from the parts side of the
boards [G] and [K].
2. Disengage the tabs (4 places) tilt up the board [K] in arrow
direction, and inspect it with the pattern side on top. At this
time, place a cloth underneath for safety (insulation).
time, place a cloth underneath for safety (insulation).
3. At the time of installation, match the board and the chas-
sis pins and install.
Warning
Electric shock may be caused when HOT
parts are touched. An electric shock will be
caused when the HOT part and the COLD
part are touched at the same time.
parts are touched. An electric shock will be
caused when the HOT part and the COLD
part are touched at the same time.
Caution
1 When the board [K] has been removed
from the chassis frame, pay attention to
prevent the coupler leads of board [K]
and board [G] from getting torn.
prevent the coupler leads of board [K]
and board [G] from getting torn.
!"
Click on the first or last page to see other TC-29P10N / TC-33P10N service manuals if exist.