Read Panasonic AG-DVX100AP / AG-DVX100AN / AG-DVX100AE / AG-DVX100EN / AG-DVC180AMC Service Manual online
MECH-2
1-2. Tension Post Position Adjustment
1. Remove the Cylinder Hold Angle and Loading Motor Unit.
NOTE: Not required remove the flexible cable from Loading Motor.
2. Turn the Mode Gear to set the Mechanism position in the play mode, that the Soft Brake of the Pad Arm Unit
just touch to the Supply Reel Table as shown in Figure.
3. Set the Mechanism Plate on the Mechanism Chassis as shown in Figure.
4. Insert the tip of minus driver to portion (A) as shown in figure and turn clockwise slowly until the surface of the
4. Insert the tip of minus driver to portion (A) as shown in figure and turn clockwise slowly until the surface of the
Tension Post comes to 2nd step (“F” Portion of tension post is just touch to “E” portion as shown in figure).
5. After adjustment, turn the Mode Gear to unloading direction then turn back to loading direction, and make sure
that position is correct at above specification in Play position.
1-3. Supply & Take-up Reel Table Height Adjustment
This adjustment should be performed for Supply or Take-up Reel Table one by one.
1. Remove the Cylinder Hold Angle and Loading Motor Unit.
NOTE: Not required remove the flexible cable from Loading Motor.
2. Turn the adjustment screw (A) on top of the Supply or Take-up Reel Table fully clockwise. Then, place the
Mechanism Plate on the Mechanism Chassis as shown in Figure.
3. Hold the Mechanism plate by finger and slowly turn the adjustment screw counterclockwise until Reel Table just
rotate with adjustment screw as shown in Figure.
4. Remove the Mechanism Plate and hold the Reel Table by finger then turn the adjustment screw
counterclockwise to 45 degrees from above step point.
Portion (A)
T side
S side
Click on the first or last page to see other AG-DVX100AP / AG-DVX100AN / AG-DVX100AE / AG-DVX100EN / AG-DVC180AMC service manuals if exist.