Read Panasonic PT-P1SDU / PT-P1SDE / PT-P1SDEA Service Manual online
fixing the A-P.C.Board block as they are removed.
7. Adjust the convergence according to the section 7.4.
"Convergence Adjustment".
8. After the adjustment, while paying attention not to vary the
adjusting result, tighten the 2 screws fixing the panel
attachment with a hexagon head wrench.
attachment with a hexagon head wrench.
Note:
·
Prepare a hexagon head wrench processed short.
9. Reassemble the projector as it was.
6.14. LCD Panel Discrimination
ID-tag seal color
LCD panel
Red
LCD panel (R)
Blue
LCD panel (B)
(No seal)
LCD panel (G)
·
Since the ID-tag seal is pasted to the FPC of LCD Panel,
(R), (G) or (B) can be easily identified by the color of the
seal.
(R), (G) or (B) can be easily identified by the color of the
seal.
·
Finally, identify the panel color by the part number printed
on the FPC.
on the FPC.
6.15. LCD Panel Combination
·
Part number is printed on the FPC of LCD Panel.
·
When replacing LCD Panel, use a component which has
the same part number as the original.
the same part number as the original.
LCD
panel
Combination1
Combination2
R
L5BDAXN00079
(L3P06S-45G10)
L5BDAXN00082
(L3P06S-46G10)
G
L5BDAXN00083
(L3P06S-46G10)
L5BDAXN00080
(L3P06S-45G10)
B
L5BDAXN00081
(L3P06S-45G10)
L5BDAXN00084
(L3P06S-46G10)
6.16. Replacement of Incidence
Polarizer (B)
1. Remove the A-P.C.Board block according to the steps 1
through 4 in the section 6.4. "Removal of J-P.C.Board".
2. Unscrew the 2 screws and remove the LCD block.
Note:
·
Be careful not to touch the surface of prism and LCD
panel.
panel.
3. Unscrew the 2 screws.
4. Remove the analysis case (upper) while expanding the 2
hooks of it outside.
16
PT-P1SDU / PT-P1SDE / PT-P1SDEA
Click on the first or last page to see other PT-P1SDU / PT-P1SDE / PT-P1SDEA service manuals if exist.