PT-DZ570U, PT-DZ570E, PT-DW530U, PT-DW530E, PT-DX500U, PT-DX500E (serv.man8) - Panasonic Projector Service Manual (repair manual). Page 13

<

PT-DZ570U/PT-DW530U/PT-DX500U/PT-DZ570E/PT-DW530E/PT-DX500E>

  4. SELF CHECK

Each self check item is displayed.

SELF CHECK

①

-

MAIN

:R1.00.00

①

- Main micon software version

②

-

SUB

:R1.00

②

- Sub micon software version

③

-

NETWOR:R1.00

③

- Network micon software version

④

-

FPGA

:R0.27

④

- FPGA version

⑤

-

FM

:R2056

⑤

- Formatter software version

⑥

-

EMULATE:DEFAULT

⑥

- Emulate setting  version 

⑦

-

OK AIR TEMP.  32/224

⑦

- Inducting air temperatuer check (C/F)

⑧

-

OK DMD TEMP. 054/104

⑧

- DMD temperature check (C/F)

⑨

-

OK OUT TEMP. 025/153

⑨

- Exhausting air temperature check (C/F)

⑩

-

OK AIR FLOW  075/054/000

⑩

- Air flow sensor check 

⑪

-

OK LAMP     0H  3OM ON

(Sensor value/AD value/compensation value)

⑫

-

OK FAN      1111

⑪

- Lamp check (liting accumulative time/lighting condition)

⑬

-

OK COLOR WHEEL

⑫

- Fan check (1:Normal/0: Abnormal)

Power/Exhaust/Lamp/DMD

⑬

- Color wheel check

  5. CW INDEX

Rotation phase is adjusted when color wheel is exchanged.
　

Procedure is written is "Section 3 (Adjustment procedure)" item 1.

  6. MODEL

Model setting is done when A PCB is replaced.

Note: This setting is not necessary when the EEPROM backup from original PCB is successful.

The setting becomes active after set and power is rebooted.

Note. For  item7 to 13, OK is shown in Red lettes

when shut down happened last time. 

INF - 7

  7. CLOG SENSOR CALIBRATION

The clog sensor circuit is calibrated.
Execute this item when A PCB or EEPROM（IC1416） or clog sensor (M2 PCB) is replaced.
　

Procedure is written is "Section 3 (Adjustment procedure)" item 1.

  1. "Picture" menu

・

Ye MODULATE

When picture mode menu is displayed, adjustment can be done by ENTER button.
ON: Ye MODULATE function is active
OFF: Ye MODULATE function is not active

  2. "Position Adjustment" menu

DVI EQUALIZER is added on the sub menu.

When noise appears with DVI input caused by length of cable or external device, set this item to lower the noise.

  3. "Advanced menu" 

"FRAME LOCK" is added on the sub menu.

Set this item when moving picture is disturbed with RGB input.

  4. "Projector setup" menu

The selections below are added on "Emulate" in the sub menu "RS-232C" setting.

-MODE_HI (Other manufacturer's mode -MODE_SH  (Other manufacturer's model)
-MODE_NE  (Other manufacturer's mod-MODE_MI  (Other manufacturer's model)
-MODE_EP  (Other manufacturer's mod -MODE_SO  (Other manufacturer's model)
-MODE_SA  (Other manufacturer's mod -OTHER  (Other manufacturer's model)

INF - 7