Read Panasonic ET-MWP100G Service Manual online
14
5. Firmware update procedure
5. 1. Equipment to be used
1. Control computer : It is used for the writing of firmware, and transmission of a command.
(It is necessary to install control software in advance. Installation instructions, please refer to the operating instructions.)
2. Communication cable : 1) USB cable (USB type B connector - PC)
2) RS-232C Streight cable (RS232 terminal - PC)
3. Firmware : Please download from the Projector service Web.
2) RS-232C Streight cable (RS232 terminal - PC)
3. Firmware : Please download from the Projector service Web.
5. 2. Setting backup of Multi Window Processor
[Notes]
・
If firmware update is performed, the Multi Window Processor all system settings will be initialized.
・
When not changing a settings of the Multi Window Processor, setting information is saved to internal SD memory,
before update and it restores after update.
before update and it restores after update.
1. Connect the Multi Window Processor to the control computer using a RS-232C cable.
2. Turn on the power of Multi Window Processor. (Power indicator will light in green.)
3. After login in the control software, click the [Backup To SD Card] button.
3. After login in the control software, click the [Backup To SD Card] button.
* System settings will be saved in the SD memory card of CPU board.
4. Please confirm the communication log of [Comm Data] page.
When save is completed, please reboot the power supply of a Multi Window Processor.
When save is completed, please reboot the power supply of a Multi Window Processor.
Computer
MWP100
RS-232C cable (Streight)
Communication conditions
for the <RS232> terminal
Click on the first or last page to see other ET-MWP100G service manuals if exist.