NN-C781JF - Panasonic Home Appliance Service Manual (repair manual). Page 20

- 20 -

(A) When mounting Primary latch switch,Secondary latch switch

and short switch to door hook assembly, mount the Primary latch
switch, the Secondary latch switch and the short switch to the
door hook assembly as shown in table.

(B) When mounting the door hook assembly to the oven assem-

bly, adjust the door hook assembly by moving it in the direction of
arrow in the illustration so that the oven door will not have any
play in it. Check for play in the door by pulling the door assembly.
Make sure that the latch keys move smoothly after adjustment is
completed. Completely tighten the screws holding the door hook
assembly to the oven assembly.

(C) Reconnect the short switch and check the continuity of the

monitor  circuit and all latch switches again by following the
components test procedures.

The output power of the magnetron can be determined by performing

IEC standard test procedures. However,due to the complexity
of IEC test procedures, it is recommended to test the magnetron
using the simple method outlined below.

Necessary Equipment:
*1 liter beaker    *Glass thermometer
*Wrist watch or stopwatch

(A) Fill the beaker with exactly one liter of tap water.Stir the water

using the thermometer and record the beaker’s temperature.
(recorded as T1).

(B) Place the beaker on the center of glass cook plate.

Set the oven for High power and heat it for exactly one minute.

(C) When one minute is elapsed, open the door and take out beaker.
(D) Stir the water again and read the temperature of the beaker.

(recorded as T2).

(E) The normal temperature rise at High power position for each

model is as shown in table.

* For continued protection against radiation hazard,

replace only with identical replacement parts(For touch
models Part No. ANE6142-1450,Type No.
V-16G-3C26-M for Primary latch switch; Part No.
A61425180AP, Type No. L-3C2-2 for Secondary latch
switch; Part No. A61785180AP, Type No. L-2C2-2 for
short switch and Part. No. AEG5J1EG12B/AEG5J1EG18B,
Type No. G5J-1-TP for power relay B(RY1))

* When the 10 Amp. fuse is blown due to the operation of

the short switch, you must replace power relay B. Primary
latch switch and the short switch. Then follow the installa-
tion procedures below.

* Interlock switch replacement  In replacing faulty

switches, be sure mounting tabs are not bent, broken or
otherwise deficient in their ability to hold the switches.

* Refer to schematic diagram to ensure proper connec-

tion.

RATED OUTPUT

1000W (IEC705-88)

TEMPERATURE RISE

Min. 15.4˚F (8.6˚C)

LATCH
SWITCH
PRIMARY

LATCH
SWITCH
SECONDARY

THE GAP SHOULD
BE LESS THAN
0.5mm WHEN DOOR
CLOSED.

SHORT
SWITCH