Read Panasonic MC-V9658-00 Service Manual online
10
of base as shown.
5. Rotate cover back. Press cover firmly until side and rear
tabs snap into place. Turn Power Nozzle upside down
and replace two (2) cover screws.
and replace two (2) cover screws.
3.2.
BULB
3.2.1.
Bulb Removal
1. Remove Power Nozzle cover (see Belt Removal).
2. Push in and turn bulb counterclockwise, then pull out to
2. Push in and turn bulb counterclockwise, then pull out to
remove.
3.2.2.
Bulb Replacement
1. Push in and turn bulb clockwise, to replace. Bulb must
not be higher than 15 Watts(130 Volts).
2. Reinstall Power Nozzle cover (see Belt Replacement).
.
3.3.
POWER NOZZLE MOTOR
3.3.1.
Specifications
1. 120V., 60Hz.
2. Amps 2.0/2.7 (max.) at 18,000/14,550 R.P.M.
3. Watts 225/298 (max.) at 18,000/14,550 R.P.M.
4. Torque 55/100 Nm at 18,000/14,550 R.P.M.
2. Amps 2.0/2.7 (max.) at 18,000/14,550 R.P.M.
3. Watts 225/298 (max.) at 18,000/14,550 R.P.M.
4. Torque 55/100 Nm at 18,000/14,550 R.P.M.
3.3.2.
Motor Replacement
1. Remove Power Nozzle cover, nozzle cover and agitator
assembly (see BELT REMOVAL.
2. Remove two (2) motor bridge screws. Lift out bridge and
motor.
NOTE: Observe routing of motor wires and all other wiring
before removing motor.
before removing motor.
3. Hook a finger under the center of the overload protector
and lift to free it from the retaining tabs. Remove the
overload protector wire terminals. Check continuity by
depressing the button completely. When the button is
released there should be continuity between the two
poles when checked. If all components and items in the
troubleshooting guide have been checked and the
overload protector continues to trip, it should be replaced.
overload protector wire terminals. Check continuity by
depressing the button completely. When the button is
released there should be continuity between the two
poles when checked. If all components and items in the
troubleshooting guide have been checked and the
overload protector continues to trip, it should be replaced.
4. Insert a flat screwdriver blade between the indicator block
assembly and the plastic retainer for the four (4) wires.
Pry up and out to free the indicator block assembly from
the retaining tabs.
Pry up and out to free the indicator block assembly from
the retaining tabs.
5. Unscrew wire nuts to free motor lead wires.
6. Install new motor. Assure motor is fully seated on all four
(4) front and rear base supports. Rear motor housing
flange should be in slot of base support.
flange should be in slot of base support.
CAUTION: Do not pinch wire.
Click on the first or last page to see other MC-V9658-00 service manuals if exist.