MC-V9658-00 - Panasonic Home Appliance Service Manual (repair manual). Page 11

11

7. Install motor bridge and secure with two (2) screws.

8. Reroute all wiring per original layout utilizing wire 

retainers provided, and proper placement of wires to 
prevent pinching of wires and interference when 
reinstalling the indicator block assembly. Connect wires 
and apply wire nuts, (reference WIRING DIAGRAM).

9. Install indicator block assembly. Holding the assembly at

a slight angle, insert the edge of the part behind the
retaining tabs (use T-shaped tab on assembly to align in
slot of retaining tab). With fingers lifting base off the floor
(to free front axle) use both thumbs to push the indicator
block assembly down until it snaps in place.

10. Install the overload protector by snapping into position 

between the two retaining tabs and with one end pushed 
up against the indicator block assembly.

11. Replace remaining parts (see BELT REMOVAL).

1. When brushes are worn to the level of the base support 

bars, replace the agitator.

1. Remove Power Nozzle cover, agitator cover, belt and agi-

tator assembly (see BELT REMOVAL).

2. Reassemble belt, agitator assembly, Power Nozzle cover, 

light bulb and light cover (see BELT REPLACEMENT).