Read Panasonic MC-E983 / MC-E985 / MC-E987 Service Manual online
15
REPLACEMENT OF MAIN PARTS
•
BRAKE LEVER UNIT
1. Remove the upper body as explained in paragraph (1)
Motor , points 1-3.
2. To remove the pedal insert a flat-head screwdriver into the
interlocking slots and press the tabs.(Fig. 20)
Fig. 21
Fig. 20
3. Remove two screws from the control panel (Fig. 21)
Fig. 17
Fig. 19
Fig. 18
(2) Power cord
1. To replace the power cord follow the disassembling process
as explained in paragraph (1) Cord reel unit, points 1-2.
2. Unwind the total length of the power cord from the cord reel.
3. Press and release the stopper on the cord reel and lift the
rail base by pushing the lower end. (Fig. 17)
4. Disconnect the power cord from the rail base and replace it.
NOTE: Observe the colour of the wires from the power cord
before reinstalling the new one. (Fig. 18)
before reinstalling the new one. (Fig. 18)
5. Insert the rail base through the cord reel slot. (Fig. 19)
NOTE: Put vaseline on the rail base before assembling the
cord reel support.
cord reel support.
6. Wind up the total length of the power cord in the arrow
direction as indicated on the spring plate.
7. Assemble the cord reel unit and cord reel support together
and refasten the screw. Then wind up the power cord 4 extra
times to maintain spring efficiency.
times to maintain spring efficiency.
8. Connect the wires according to the schematic diagram and
reinstall the cord reel assembly in its place. Then reassemble
the remaining parts in the reverse order.
the remaining parts in the reverse order.
Rail base
Blue wire
Brown wire
Stopper
Click on the first or last page to see other MC-E983 / MC-E985 / MC-E987 service manuals if exist.