Read Panasonic WV-CW860 / WV-CW864E Service Manual online
– 8 –
4.2. Setting Up for the Remote E.V.R.
Adjustment Kit
< Remote E.V.R. Adjustment Kit >
8
Fig. 4-2 shows the Remote E.V.R. Adjustment Kit.
Fig. 4-2
< Switch Setting >
8
Referring to Fig. 4-3, remove four screws that secure the
Upper Cover and remove the Upper Cover.
Fig. 4-3
8
Set the switch SW3 on the board to the position as shown
in Fig. 4-4.
Fig. 4-4
8
Set the VP/STD CAMERA selection switch on the rear
panel to STD CAMERA position.
<Rear>
<Fr
ont>
Board
SW3
ON
<SW3>
1
2
3
4
Select switch #2 to
ON position.
ON position.
Remove four screws.
Upper Cover
REMOTE
OPERATE
PROG
ALARM
RESET
RESET
NORMAL
SYSTEM
ALARM OFF
EVR
Left
Switch
Right
Switch
Mode Selection
Switch
Program
Switch
Up
Switch
Down
Switch
Set
Switch
IN
OUT
STD. CAMERA
VP CAMERA
VIDEO
CAMERA
DC12V IN
RS232C
VP/STD Camera Selection Switch
RS232C Connector
REMOTE
OPERATE
PROG
ALARM
RESET
RESET
NORMAL
SYSTEM
ALARM OFF
EVR
< Menu Setting >
8
Set the Mode Selection Switch on the Front Panel to the
"ALARM OFF"(center) position.
8
Keep pressing the Program Switch for 3 seconds or more
until "Program Menu" is displayed on the monitor screen.
8
Move the cursor to the "Controller Set Up" position by
pressing the Up and Down Switch.
8
Display the "Controller Set Up Menu" on the monitor by
pressing the Set Switch.
8
Move the cursor to the "Set Up Disable" position by
pressing the Up and Down Switch.
8
Change "Disable" to "Enable" by pressing the Set Switch.
8
After completing above setting, move the cursor to the
"Communication" position by pressing the Up and Down
Switch.
8
Display the "Communication Menu" on the monitor by
pressing the Set Switch.
8
After confirming the Baud Rate is 9600, finish this menu
by pressing the Program Switch twice.
< Installing E.V.R Adjustment Program >
8
The Example given here is for A 2 drive computer, your
procedure might vary slightly depending on the drive
configuration.
8
Confirm that the contents of CONFIG.SYS file on your
computer is DEVICE=ANSI.SYS(Basic).
8
Insert floppy disk containing E.V.R. adjustment program
into your floppy drive (for example,drive:A) and type A:
8
At the prompt, type CD IBMPC and press ENTER key.
8
Type COPY RADJ2.EXE B: and press ENTER key.
8
Type CD\ and press ENTER key.
8
Type CD SEQ and press ENTER key.
8
Type COPY CW860E.SEQ B: and press ENTER key.
8
Type COPY CW860AF.SEQ B: and press ENTER key.
8
Type COPY CW860TLT.SEQ B: and press ENTER key.
8
Type CD\ and press ENTER key.
8
Type CD EVR and press ENTER key.
8
Type COPY CW860E.EV2 B: and press ENTER key.
8
Type COPY CW860EAF.EV2 B: and press ENTER key.
8
Type COPY CW860ETL.EV2 B: and press ENTER key.
8
After completing installation of program, you are ready to
use the E.V.R. adjustment program.
Click on the first or last page to see other WV-CW860 / WV-CW864E service manuals if exist.