WJ-HD500B - Panasonic Video Monitoring Service Manual (repair manual). Page 4

– 1-1 –

REMOTE

TIMER

OPERATE

FULL

HDD

SEQUENCE

SET

LOCK

ALARM

ALARM

RESET

ALARM

SUSPEND

MULTISCREEN

SELECT

SETUP

/ESC

GROUP
SELECT

SPOT
MULTISCREEN

DAYLIGHT SAVINGS

EL-ZOOM

COPY

REC PREVIEW

INDEX

STOP

BPLAY/    PAUSE

REC

FWD

REV

ALARM SEARCH

DISPLAY

REC STOP

1

2

3

4

13

14

15

16

9

10

11

12

5

6

7

8

Digital Disk

Recorder

WJ-HD              B

FS

16

q

w

e

t y u !0

!1

r

i o

!3 !4 !5 !6

!7

!8

!9

@0

!2

@1

@3

@4

@5

@6

@2

@7

@8

@9

#0

#1

q

Operate Indicator (OPERATE)
Is on when the power of the WJ-HD500B Digital Disk
Recorder is turned on.

w

Timer Indicator (TIMER)
Lights to indicate when the TIMER is set to INT (internal
timer) in the setup menu.

e

Remote Indicator (REMOTE)
Lights to indicate when the Disk Recorder is controlled
by an outboard device via the Serial or 10/100BASE-T
port on the rear of the Disk Recorder.

r

Alarm Suspend Indicator (ALARM SUSPEND)
Lights to indicate that the alarm suspension mode is
selected.

t

Alarm Reset Button (ALARM RESET)
This button cancels an activated alarm.
Pressing this button will reset the alarm and return the
system to the condition before the alarm function was
activated.

y

Alarm Indicator (ALARM)
This indicator blinks to indicate that an alarm condition
exists.
It changes to a steady light when the alarm is reset auto-
matically.
To turn the indicator off, press the ALARM RESET but-
ton.

u

Sequence Button (SEQUENCE)
Runs the assigned sequence on the selected monitor
screen for the specified duration. 
During the sequence, pressing this button will pause the
sequence that is being run on the monitor screen.
The LED indicates the status as follows.

On: Sequence is being run.
Blinking: Sequence is in pause mode.

i

Multiscreen Selection Button 
(MULTISCREEN SELECT)
Selects the multiscreen pattern to be displayed on the
Multiscreen Monitor that is connected to the MULTI
SCREEN OUT on the rear of the Recorder.
Pressing this button will toggle the display on the moni-
tor screen as shown below.

→

→

→

→

→

→

4 screen segments

o

Monitor Selection Button (SPOT / MULTISCREEN)
Selects to control the display on the screen for either the
Spot or Multiscreen Monitor.
Pressing this button will toggle the indicator in the button
on and off to indicate the selected monitor as shown
below.

On: Indicates the Spot monitor is selected.
Off: Indicates the Multiscreen monitor is selected.

!0

Lock Button (LOCK)
Toggles to enable or disable the button lock function on
both front panels of the Disk Recorder and Remote
Controller. 
The LED indicates the status as shown below.

On: The button lock is enabled.
Off: The button lock is disabled.

While On, the button lock will be released only if the pre-
set password is entered in the password inquiry window.

!1

Numeric Buttons (1 - 16)
These buttons are used for numeric input into the sys-
tem such as the video selection, password, etc.
The indicator in the button lights up to indicate as shown
below.

Green: The input is displayed on the monitor.
Yellow: The input is displayed on the monitor and

recorded on the Hard Disk.

Orange: The input is recorded on the Hard Disk (no dis-

play).

■