WJ-HD200 - Panasonic Video Monitoring Service Manual (repair manual). Page 8

– 1-3 –

When operating alarm recall (ALARM RECALL):

Holding down the JogDial for two seconds will open
or close the alarm event log on the monitor.
Rotating the JogDial will scroll up or down the log
page.
After selecting an alarm event with [

D

] or [

C

] but-

ton, press the [PLAY] button to start playing back the
selected alarm record.

When operating setup menus:

Pressing the JogDial validates the selected parame-
ter and moves the cursor to the next position.
Rotating the JogDial increases or decreases the
parameter.

@6

An RCA standard type jack supplies audio output signal
that is identical to the AUDIO OUT terminal on the rear
panel.

@7

An RCA standard type jack supplies video output signal
that is identical to the MULTI OUT terminal on the rear
panel.

SIGNAL GND

POWER

DATA

10/100BASE-T

MODE

RS-232C

MULTI

SCREEN OUT

SPOT

OUT

1

1

ALARM/REMOTE

OFF

ON

2

2

3

3

4

4

5

5

6

6

7

7

8

8

OUT

VIDEO

OUT

AUDIO

IN

IN

#1

#3

#0

#2

#4

#6

#9 $0

#5

#7

#8

$1

$2 $3

$4

■

#0

An RCA standard jack accepts an unbalanced –10 dBV,
10 k

Ω

line input audio signal supplied from an external

device.

#1

An RCA standard jack supplies an unbalanced –10 dBV,
600 

Ω

line output audio signal to an external device.

#2

This BNC accepts a video signal supplied from a cam-
era. A 75 

Ω

termination is made unless the video output

terminal is connected.

#3

This BNC supplies a video signal looped through the
video input terminal. 

#4

This BNC supplies a full-screen live image signal to the
spot monitor while recording or not recording. No play-
back or split image, setup menu, or OSD information is
supplied via this connector.

#5

This BNC provides the multi-screen monitor with the fol-
lowing video.

• Live image: single spot, multi-split spot, single

sequence, quad-split sequence

• Playback image: single spot, multi-screen spot
• OSD information: camera title, time and date,

recorder status, alarm status 

The menu setup windows are also provided via this
BNC.

#6

This port accepts the alarm inputs 1 – 8, and remote
controls while supplying status outputs.

#7

This 9-pin port is used to communicate with the personal
computer when controlling the recorder, or updating the
firmware installed in the recorder.

#8

A 6-bit switch is used for such system setups as disk for-
matting, PSD chain termination, and so forth.

#9

This port is used to exchange control data with Ethernet
via an Ethernet Hub.

$0

This port is used to communicate with the external
devices compatible with the PSD (Panasonic Security
Data) protocol based on RS485.

$1

Prevents the temperature of the recorder from rising. Do
not block the ventilation openings.

$2

This switch turns the power of the recorder on and off.

$3

$4

Is connected to an AC outlet.