Read Panasonic WJ-HD100 Service Manual online
– 3 –
# 22
Status Out Terminal
These terminals supply the following status information:
PLAY OUT, REC OUT, AUTO OFF OUT, DISK END
OUT.
AUTO OFF OUT: AUTO OFF OUT signal turns active
(active when low), and playback or recording stops when
a temperature error is detected inside the unit. Turn the
power off and wait for a while until you turn it on again to
reset the error.
PLAY OUT, REC OUT, AUTO OFF OUT, DISK END
OUT.
AUTO OFF OUT: AUTO OFF OUT signal turns active
(active when low), and playback or recording stops when
a temperature error is detected inside the unit. Turn the
power off and wait for a while until you turn it on again to
reset the error.
#33
Series Record Terminal
Connect these terminals when using multiple units in
series or loop connection.
series or loop connection.
#44
Alarm Terminal
These terminals supply and receive the following alarm
related information: ALARM RECALL, ALARM OUT,
ALARM RECOVER OUT, ALARM RESET IN, ALARM
IN.
related information: ALARM RECALL, ALARM OUT,
ALARM RECOVER OUT, ALARM RESET IN, ALARM
IN.
#55
Cooling Fan
Do not block the air flow of this cooling fan through the
openings on both sides of the top cover to prevent the
appliance from overheating.
openings on both sides of the top cover to prevent the
appliance from overheating.
#66
Power Switch [POWER ON OFF]
Turns the power on and off. The OPERATE indicator on
the front panel lights while the power switch is turned on.
the front panel lights while the power switch is turned on.
#77
Signal Ground [SIGNAL GND]
Connect with the terminals of other devices as neces-
sary to avoid grounding loop and noise.
sary to avoid grounding loop and noise.
#88
Power Cord
Click on the first or last page to see other WJ-HD100 service manuals if exist.