BB-HCM705CE - Panasonic Video Monitoring Service Manual (repair manual). Page 13

13

Reset Voltage: 2.9 V 
Package: 5 pin SOT-23-5
Operation Outline: When 3.3V power starts up, it emits about 50ms reset pulse after detecting 2.9V.

Operation Outline: By pressing the Function Switch you can stop access to the SD card and then remove it.

 Operation Outline: By pressing the Factory Default Reset Switch, all of the camera's settings are reset to their factory default
settings.

Operation Outline: Restart SW (SW103) is connected to RESET IC for a manual reset, and the hardware is reset when this SW
is pressed.

Operation Outline: IC404 is RTC (Real Time Clock), and is used for time setting of image transfer, etc. This is backed up by a
lithium battery (BAT501) even at the time of power OFF. 
There is an RTC block inside IC101, and this inside RTC block operates during the existence of electricity by importing the clock
data from IC404 at the time of power ON.

Power Supply Voltage: 3.3 V 
Operation Outline: An SD memory card control block is included on IC101, and used by connecting an SD card slot (CN301)
There is a green LED (LED301) near the SD card slot, and it lights while the SD card is being accessed.

• IC202 is a vMaicovicon image sensor module with approx. 1.3 million pixels, and outputs the image signal (DOUT0-11) in 4VGA

size (1980x960).

• IC202 outputs Pixel clock (CAMCLK_48 MHz), VD,HD signals based on the timing of input Pixel clock (CLOCK_27 MHz) from

the CPU board.

• IC202 is controlled by CPU using the serial signal (RESET, CS, SI, SO, SCLK).
• IC202 required 3.3 V, 1.8 V from CPU board and 1.2 V which is sent from IC203.
• IC201 is used as the 1-Kbit EEPROM for the setting of images.
• IC201 is controlled by CPU using the I2C(SCL, SDA) signal.
• IC201 required 3.3 V for the power supply of Camera Unit. +3.3V is input from CPU unit.