WP-8204PT - LG Washing Machine Service Manual (repair manual). Page 13

-13-

If water leakage occures at the spin tub after assem-
bling the bellows assembly and the bellows supporter,
it colud cause an electrical shock or a fire, therefore
they should be securely assembled again.

After removing the back cover, refer to the figure and
proceed as follows :

(1) Disconnect the plunger valve strap from the rod.
(2) Unscrew and remove the screws fastening the

plunger valve cover. (fig.41)

(3) Push 4 hooks to the inside and pull out the plunger

valve cover. (fig.41)

When removing the plunger valve cover, do not use a
screw driver or pliers, etc.,
Damage to the plunger valve cover may cause water
leakage.

After removing the back cover, refer to the figure and
proceed as follows :

(1) Disconnect the lead wires of the drain pump

assembly.

(2) Disconnect all hoses(drain hose-D and Drain hose-

C) from the drain pump assembly. (fig.42)

Fig.41

To assemble the plunger valve case, reverse the
above disassembly.

When replacing the plunger valve case, take care not
to damage and cause water leakage.

Fig.42

(3) Lay the washing machine on its front side on a

blanket or cardboard.

(4) Hold the drain pump assembly and remove the

screws fastening the drain pump assembly from the
base bottom. (fig.43)

Fig.43

(5) Remove the drain pump assembly

To assemble the drain pump assembly, reverse the
disassembly provedure.

Apply adhesive or use hose clamps on all joints to
ensure their water tightness.

WP 830

29/8/04, 10:51 PM

13