WP-8204PT - LG Washing Machine Service Manual (repair manual). Page 12

-12-

(6) Unscrew the pulsator pulley fixing bolt and remove

the pulsator pulley. (fig.35)

The bellows assembly attached to the unit can not be
removed unless it is torn off.

After removing the spin dryer basket assembly, refer to
the figure and proceed as follows :

(1) Remove the bellows assembly. (fig. 38)
(2) Remove the bellows supporter by using slip joint

pliers on the spin tub bottom. (fig. 38)

Fig.35

Fig.36

(7) Unscrew and remove the screws fastening the gear

case assemly at the tub. (fig.36)

To assemble the gear case assembly to the tub,
reverse the above disassembly.

Don’t disassemble 3 screws fixing the gear case.
Check the assembled condition of the pulsator packing
at the tub hold when you assemble the gear case
assembly. (fig.37)

Fig.37

Fig.38

The assembly procedure as follows :

(1) Insert the  bellows assembly into the bellows

supporter.

Fig.39

(2) Fit them by pushing the bellows assembly and the

bellows supporter at the same time into the spin tub
bottom. (fig.39)

(3) Pass the spin shaft through the center hole of the

bellows assembly and insert it into the coupling
assembly. (fig.39)

(4) Tighten the bolt of the coupling assembly while

adjusting it to the cutter split made in the spin shaft.
(fig.40)

Fig.40

Pulsator packing

Tub

Gear case

WP 830

29/8/04, 10:51 PM

12