Read LG SW6D2 Service Manual online
-12-
5. Unscrew the pulsator pulley fixing bolt and remove
the pulsator pulley. (Fig.37)
6. Unscrew and remove the screws fastening the gear
case assembly at the tub(Fig.38).
After removing the spin dryer basket assembly, refer
to the figures and proceed as follows:
1. Remove the bellows assembly
1. Remove the bellows assembly
(Fig.40).
2. Remove the bellows supporter by using slip joint
pliers to the spin tub bottom
(Fig.40).
The assembly procedure is as follows:
1. Insert the bellows assembly into the bellows
1. Insert the bellows assembly into the bellows
supporter.
2. Fit them by pushing the bellows assembly and the
bellows supporter at the same time in the spin tub
bottom
(Fig.41).
3. Pass the spin shaft through the center hole of the
bellows assembly and insert it into the coupling
assembly
(Fig.41).
NOTE
1. Don't disassemble four screws fixing the
gear case
assembly.
2. Check the assembled condition of the
packing-P at
the tub hole is right when youassembled the gear
case assembly. (Fig.39)
The bellows assembly attached to the unit
cannot be removed unless it is torn off.
NOTE
NOTE
NOTE
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
Tub
Packing-P
Gear case
4-7. Bellows Assembly Replacement
Fig.37
F
ig.38
Fig. 39
Fig.4
0
Fig. 41
NOTE
NOTE
Click on the first or last page to see other SW6D2 service manuals if exist.