Read LG 32LD660 / 32LD665H (CHASSIS:LA05C) Service Manual online
- 18 -
10. Checking the EYE-Q operation.
Step 1) Press the EYE Key on the Adjustment remote
controller.
Step 2) Screen the Eye Q sensor in front of the TV by hands,
and keep up about 6 seconds.
Step 3) Checking “ Lux” value is changed less than “ 100” , or
not. If the values are not changed, exchange the
sensor unit by soldering.
sensor unit by soldering.
Step 4) Pull out the hands, keep up about 6 seconds.
Step 5) Checking “ Lux” value increase from “ 50” , or not.
If the values are not changed, exchange the sensor unit by
soldering.
Step 5) Checking “ Lux” value increase from “ 50” , or not.
If the values are not changed, exchange the sensor unit by
soldering.
11. Test factor for commercial model
11.1 MPI Communication check
11.1.1 The method of cable connecting from JIG to TV
1) Operate JIG(Commercial Check JIG) as shown on
1) Operate JIG(Commercial Check JIG) as shown on
picture 1.
2) In the right side of check jig, 11 pin SPI/MPI signal cable
is connected to MPI dummy board.
11.1.2 Test sequence
1) Press EYE using adjust remote-control.
2) Then, tuning the channel 96-1.(Lodgenet digital1.)
1) Press EYE using adjust remote-control.
2) Then, tuning the channel 96-1.(Lodgenet digital1.)
automatically.
3) Check “OK” message on TV screen as shown on
picture2.
4) If you find any problem. press <EYE> button and retest.
< step 1>
< step 4>
< step 5>
< step 2>
< step 3>
Click on the first or last page to see other 32LD660 / 32LD665H (CHASSIS:LA05C) service manuals if exist.