LB-D2460HL - LG Air Conditioner Service Manual (repair manual). Page 17

■

Connect the wires to the terminals on the control board individually according to the outdoor unit connection.
• Ensure that the color of the wires of outdoor unit and the terminal No. are the same as those of indoor unit

respectively

■

24K Btu

1) Arrange 2 power cables on the control panel.
2) First, fasten the steel clamp with a screw to the inner boss of control panel.
3) For the cooling model, fix the other side of the clamp with a screw strongly.

For the heat pump model, put the 0.75mm

2

cable(thinner cable) on the clamp and tighten it with a plastic

clamp to the other boss of the control panel.

4) In Australia, the length of power supply cord measured from the entry of the power supply cord to the middle

of live pin on the power plug should be over 1.8m.

POWER INPUT

POWER
INPUT

1(L) 2(N)

4(N)

5

6

7

8

3(L)

4(N)

5

6

7

3(L)

Terminals on the indoor unit

Terminals on the outdoor unit

1(L)

2(N)

 

connected to the outdoor unit should be 

complied with the following specifications (Rubber 
insulation, type H05RN-F approved by HAR or SAA).

The connecting cable connected to the indoor and outdoor 
unit should be complied with the following specifications 
(Rubber insulation, type H05RN-F approved by HAR or SAA).

20mm

GN/YL

20mm

GN/YL

–17–

If the supply cord is damaged, it must be replaced by a special cord or assembly availible from the 
manufacturer of its service agent.

Make sure that the screws of the terminal are free from looseness.