SB 100 (serv.man3) - JBL Audio EMC - CB Certificate (repair manual). Page 3

Page 3 of 68 

Report No.: 350-120154AX

 

 

TRF No. IEC60065K 

 
 
List of Attachments (including a total number of pages in each attachment):  
- 

Manufacturer’s Declaration: 1 sheet 

- 

Photograph: 8 sheets / 15 Figs 

1)  The sample tested complies with the requirements of the test specification. 

2)  The subject models CINEMA SB100 and CINEMA STV100 are same except for model designation. 

Unless otherwise specified, all tests were performed on model CINEMA SB100. 

3)  As for Power Transformer (T5311), multi factories will produce them as alternative use. Since it was 

same to each other on construction and electrical characteristics, the difference of factory did not affect 
safety aspects.  
Unless otherwise specified, all tests were conducted on the following transformer as representative. 
T5311:  SUNSHINE Electronics Co., LTD / BCK-BH140 

4)  Following symbols and abbreviations are used in this test report. 

S/C= Short-Circuit 

 

O/C= Open-Circuit 

MT= Mains Transformer              TW= Transformer Winding (measured by resistance method) 
TC= Transformer Core               TP= Thermal Protector 
NH= No Hazard Occurred 

NFR= No Further Results existed 

+ = total overheated areas of the printed board(s) are not larger than 2 cm². 
LC= Lead Connection on the printed board 
PCB= Printed Circuit Board 
IE= Inside of Enclosure               OE= Outside of Enclosure 
KH= Knob, Handle 

 

PW= Primary Wire 

IB= Insulating Barrier 

E = Emitter 

 

 

C = Collector 

 

B = Base 

* = Determined by the method specified in Note f to Table 3. 
 

Tests performed (name of test and test clause): 
Full tests 

Testing location:  see page 2 (Testing procedure 
and testing location) 

Summary of compliance with National Differences 
List of countries addressed: EN, AU, NZ, KR, MY, UA, JP 

SG, KE, BR, RU (no national differences in CB-Bulletin)