JSR 675 - JBL Audio User Guide / Operation Manual. Page 7

6

Select one of 30 preset locations to
recall the station stored in memory. The
input function is automatically changed
to TUNER when the button is pressed.
When you select numbers from 10
through 29, you must select the second
digit within about 2 seconds. To select
preset 30, simply press 0.

Set TAPE 2 MONITOR button to the “off”
position when you want to hear the other
input functions. Press this button to
monitor the cassette deck connected to
the TAPE 2 MON input jacks.

Press the button to select the desired input
function:  VCR 1, VCR 2, VDP, TAPE 1,
TV/Aux, Tuner, CD or Phono.

To dub from VCR 2 to VCR 1, press the
VCR 2 button and then press the VCR 1
REC button.

For the input function of VCR 1 press
the VCR 2 button and VCR 1 DUBBING
button. Set the recording VCR (VCR 1)
to recording mode. Set the playback
VCR (VCR 2) to play a tape.

Dubbing will start.

■

To hear another input source during
videotape dubbing:  Press the input
function you want to hear, and play
the input source.

If you press the TEST TONE

button during VCR 1 DUBBING, the
audio signal is not recorded.

Push in this button to select the VCR 2
jacks on the front, rather than the VCR 2
jacks on the rear.

Connect to the VIDEO OUTPUT jack of a
VCR (Yellow jack).

Connect to the AUDIO OUTPUT jacks of a
VCR (Red and White jacks).

Press this button to compensate for the
response of the human ear at low listening
levels (known as the Fletcher-Munson
hearing curve). The high and low frequen-
cies are automatically boosted when this
button is pushed in. In the OFF position,
the frequency response is flat at all
volume levels. This button does not work
at high volume levels.

Turn the VOLUME clockwise to
increase the volume and counter-
clockwise to decrease it. The vol-
ume of the front, center, and rear
channels is changed at the same
time.

This indicator moves in accordance
with the volume level. The indicator
blinks when the mute button on the
remote commander is pressed.

This window shows the state of
operation for easier control of the
receiver. It also contains the IR
Remote Sensor.

 JSR675 OM (230V)  7/28/98 10:08 AM  Page 8