JSR 655 - JBL Audio User Guide / Operation Manual. Page 6

5

times in succession. Use this button
to test speaker connections.

Press the VCR 2 button and VCR 1
DUBBING button. Set the recording
VCR (VCR 1) to recording mode. Set
the playback VCR (VCR 2) to play-
back mode.

Dubbing will start.

■

To hear another input source dur-
ing videotape dubbing:  Press the
input function you want to hear,
and play the input source.

If you press the TEST TONE

button during VCR 1 DUBBING, the
audio signal is not recorded.

Press this button to scan the preset
station frequencies. The receiver stops
at each preset location that contains a
frequency for about 4 seconds, so you
can hear a station. The preset location
indicator blinks 4 times. Press this

button again to stop scanning.

Press this button to select AUTO or
MANUAL tuning.

■

In AUTO mode, scanning is auto-
matically continued up or down
until the next station is picked up
by pressing the UP/DOWN tuning
button. The display window shows
SEARCH. Use this mode to quickly
find strong AM or FM stations.

■

In MANUAL mode, the frequency
is changed by a step with the
UP/DOWN button. If you keep
pressing the UP/DOWN tuning
button, scanning is continued until
the button is released.

Tuning Intervals:

BAND

EUROPE /AUSTRALIA

FM

50 kHz

AM

9 kHz

Press this button to select stereo or
mono mode.

■

Provides stereophonic

reception of an FM stereo broad-

cast. The display window shows
STEREO.

■

The left and right channel

signals detected from an FM
stereo broadcast are mixed and
reproduced through both chan-
nels. If you want to find a weak FM
station, select this mode. The dis-
play window shows MONO.

Use this button to store an AM or FM
frequency. Press this button and
select one of 30 preset locations to
store the frequency with the STATION
PRESET buttons while the memory
indicator blinks MEMORY.

When you store a frequency

in a memory location that already
contains a frequency, you replace the
previous frequency. If your receiver is

disconnected from AC power for
more than about 10 days, it loses all
stored frequencies.

Press the DOWN button 

▼

to tune in

lower frequency stations, the UP
button 

▲

to tune in higher frequency

stations. If you press the DOWN
button when the display is at the
bottom of the frequency range, the
display returns to the top of the
range. If you press the UP button
when the display is at the top of the
frequency range, the display returns
to the bottom of the range. When the
receiver finds a strong frequency, the
display window shows TUNED.

Press these buttons to select the FM
or AM radio band. When you select
the AM or FM radio band, the receiver
displays the last frequency selected
on that band.

Select one of 30 preset locations to
recall the station stored in memory. The
input function is automatically changed

 JSR655om (a) qx  7/28/98 9:54 AM  Page 7