CS 360Xcite (serv.man2) - JBL Audio Service Manual (repair manual). Page 15

•  Make sure the subwoofer is plugged into an active AC 

wall outlet.

•  Make sure the Master Power Switch, located on the 

rear of the subwoofer, is in the On/Standby position.

•  Make sure there is a source – for example, a DVD 

Player, CD Player, VCR or television – hooked up to 
one of the four input jacks.

•  Make sure that the program material is playing.
•  Recheck the hookup  connections, referring to the 

Speaker Connections section.

•  Make sure that the processor is in the 3-Stereo 

mode. If it is in Phantom or Stereo mode, the center 
speaker will not play.

•  Increase the level of the center channel, using the 

level-adjustment instructions earlier in this manual.

•  Check the connections between the subwoofer and 

the center speaker.

•  Experiment with placement of the subwoofer. 

Remember, place the subwoofer in a 
corner to get maximum bass output from the system.

•  Increase the subwoofer level, using the level-

 adjustment instructions found  earlier in this manual.

•  Increase the level of bass, using the remote control.

The internal software version may be checked by 
pressing the ON Button on the remote when the unit 
is already switched ON. The software version number 
appears as a small "v", followed by a sequence of 
digits.

Optional Floor Stands are 
available from your JBL Dealer 
(Order code: CSSTANDS).