CS 360Xcite (serv.man2) - JBL Audio Service Manual (repair manual). Page 12

English

The CS360 System enters SETUP when you press and hold 
the MENU Button on the Remote Control for 3 seconds. 

The Front Display now shows the word TEST blinking. Press 
the [<] or [>] Navigation Button 

F on the Remote to 

scroll through the options. If scrolling with the Right 
Navigation Button, the Display shows these (blinking) 
words in the following order:

TEST – LEVELS – UNITS – DISTNC – LIPSNC – DISPLY - ON 
VOL – NAME - AU ON - AU SRC - RESET? - And TEST again.

Select any of these functions for adjustment by pressing 
the SET Button 

4 on the Remote. See below for explana-

tion of each adjustment.

If you want to leave the SETUP Mode at any time, press 
the EXIT Button 

E on the Remote once or twice.

 If the unit is left in SETUP mode or its sub-menus 

for 60 seconds without any user commands, the unit 
leaves SETUP menu and returns to regular operation.

 In SETUP, when a selection has sub-selections 

(such as LEVELS having a sub-selection of Front Left, Cen-
ter, Front Right, ……), this selection blinks to prompt you 
to press SET to enter the next menu layer. If a menu item 
offers no further options (such as Front Left Speaker in 
the LEVELS menu), the indication does not blink.

To enter the SETUP menu, first press the MENU Button 
for two seconds. When the Display shows the word TEST 
blinking, either acknowledge with the SET Button to enter 
the TEST tone menu, or move forwards or back between 
the Setup options with the RIGHT ARROW or LEFT ARROW 
Buttons. The following explanations follow the Setup 
Functions as you see them if using the RIGHT ARROW to 
circulate through the menus.

After pressing the SET Button, a pink noise test signal 
circulates between the three speakers and the subwoofer, 
(sound from the subwoofer only if SUBWFR is ON). While 
the test signal is heard from each speaker, the Display 
shows which one you are listening to, as well as the level. 
(FL for Front Left, C for Center, FR for Front Right, S for 
Subwoofer). Adjust the output level by pressing the Up or 
Down Navigation Buttons. Initial level for all speakers is 
shown as “0”, and may be increased to +10 or decreased 
to -10, except the subwoofer, which may be increased to 
+20. The noise is heard from each speaker for 5 seconds, 
and if no action or adjustment is done, it goes to the next 
speaker. You can circulate between the speakers quickly 
by pressing the RIGHT ARROW Button. The system stays in 
TEST mode until you press EXIT or SET. SET or first press 
of EXIT will take you to the next SETUP item (LEVELS). A 
second press of EXIT button will cause the system to leave 
the SETUP menu.

Here you can adjust the level of each speaker while lis-
tening to normal music or any other program material of 
your choice. (No test tone or pink noise is heard). Press 
SET when LEVELS blinks on the Display. The Display shows 
“FL  0” for Front Left Channel, standard level. Increase or 
decrease the Level with the Up and Down Navigation But-
tons, and move through the four speakers with the Left 
and Right Navigation Buttons, adjusting each one accord-
ing to taste. When you are done, press SET or EXIT to jump 
to the next SETUP item.

Units lets you select either meters or feet for setting 
speaker distances. This selection is relevant only if you 
want to adjust Distance (next point).

Adjusts perceived speaker Distance from user by add-
ing delay. Select each speaker in turn with the Left and 
Right Navigation Buttons and adjust the distance from 
0.0 meters to 9.0 meters to reflect the actual distance 
between yourself and each speaker. Press SET or EXIT to 
jump to the next item.