Read Harman Kardon SOUNDSTICKS III (serv.man2) EMC - CB Certificate online
IEC 60950-1 (ed.2)
- Page 4 of 7 -
www.nemko.com
Report No. 158002
3.2.3 Permanently
connected
equipment has provision
for connecting and securing a field wiring system
(i.e. conduit, or leads etc.) per the NEC
(i.e. conduit, or leads etc.) per the NEC
The equipment is not
permanently connected to the
mains.
permanently connected to the
mains.
N/A
3.2.3
Permanently connected equipment may have
terminals or leads not smaller than No. 18 AWG
(0.82 mm²) and not less than 150 mm in length
for connection of field installed wiring.
terminals or leads not smaller than No. 18 AWG
(0.82 mm²) and not less than 150 mm in length
for connection of field installed wiring.
The equipment is not
permanently connected to the
mains.
permanently connected to the
mains.
N/A
3.2.3
If supply wires exceed 60 °C, marking indicates
use of 75 °C or 90 °C wiring for supply
connection as appropriate.
use of 75 °C or 90 °C wiring for supply
connection as appropriate.
The equipment is not
permanently connected to the
mains.
permanently connected to the
mains.
N/A
3.2.3 Equipment
compatible
with suitable trade sizes of
conduits and cables.
The equipment is not
permanently connected to the
mains.
permanently connected to the
mains.
N/A
3.2.5
Length of power supply cord limited to between
1.5 and 4.5 m unless shorter length used when
intended for a special installation.
1.5 and 4.5 m unless shorter length used when
intended for a special installation.
Class III equipment.
N/A
3.2.5
Conductors in power supply cords sized per NEC Class III equipment.
N/A
3.2.5
Power supply cords and cord sets incorporate
flexible cords suitable for the particular
application.
flexible cords suitable for the particular
application.
Class III equipment.
N/A
3.2.6
Strain relief provided for non-detachable
interconnecting cables not supplied by a limited
power source.
interconnecting cables not supplied by a limited
power source.
Class III equipment.
N/A
3.2.9
Adequate wire bending space and volume of field
wiring compartment required to properly make
the field connections.
wiring compartment required to properly make
the field connections.
The equipment is not
permanently connected to the
mains.
permanently connected to the
mains.
N/A
3.2.9
Equipment solely for installation in Restricted
Access Locations using low voltage d.c. systems
may not need provision for connecting and
securing a field wiring system when wiring is
protected from abuse.
Access Locations using low voltage d.c. systems
may not need provision for connecting and
securing a field wiring system when wiring is
protected from abuse.
The equipment is not
permanently connected to the
mains.
permanently connected to the
mains.
N/A
3.3
Field wiring terminals provided for
interconnection of units for other then LPS or
Class 2 circuits also comply with 3.3.
interconnection of units for other then LPS or
Class 2 circuits also comply with 3.3.
Class III equipment.
N/A
3.3
Interconnection of units by LPS or Class 2
conductors may have field wiring connectors
other than specified in 3.3 if wiring is reliably
separated
conductors may have field wiring connectors
other than specified in 3.3 if wiring is reliably
separated
Class III equipment.
N/A
3.3.1
Terminals for the connection of neutral conductor
identified by a distinctive white marking or other
equally effective means
identified by a distinctive white marking or other
equally effective means
Class III equipment.
N/A
3.3.3
Wire binding screw terminal permitted for
connection of No. 10 AWG (5.3 mm²) or smaller
conductor if provided with upturned lugs, cupped
washer or equivalent retention.
connection of No. 10 AWG (5.3 mm²) or smaller
conductor if provided with upturned lugs, cupped
washer or equivalent retention.
Class III equipment.
N/A
3.3.4
Terminals accept US wire sizes (gauge)
Class III equipment.
N/A
3.3.4
Terminals accept current-carrying conductors
rated 125% of the equipment current rating.
rated 125% of the equipment current rating.
Class III equipment.
N/A
Click on the first or last page to see other SOUNDSTICKS III (serv.man2) service manuals if exist.