SIGNATURE 1.3 (serv.man5) - Harman Kardon Audio User Guide / Operation Manual. Page 11

8

If your installation has followed the procedures in this
manual, you should enjoy many years of trouble-free
operation and high-quality listening enjoyment. The 1.3
does not contain any user-serviceable parts. If you suspect
a problem that may require service assistance, contact
your dealer, installer or an authorized Harman Kardon
service depot.

You may also contact Harman Kardon via the World Wide
Web at www.harmankardon.com

It is important that any repairs be carried out only by an
authorized Harman Kardon service agent to ensure proper
service and preserve the protection of your Limited
Warranty. It is a good idea to keep your sales slip or
receipt in a safe place (along with this manual) so that it
will be available to verify the purchase date for warranty
claims.

Under some conditions, such as a shorted speaker wire,
DC voltage on an input connection or thermal overload,
the amplifier will place itself in a “protect” mode to
prevent damage to the amplifier. When this happens, the
LED Power Indicator will flash and alternate between red
and amber.

When this occurs, IMMEDIATELY turn off the unit using
the power switch and correct the problem. Then turn the
unit back on. If the unit continues to go into a protect
mode, contact your dealer or installer for assistance.

The items listed below are a brief guide to minor problems that may arise with audio equipment such as the 1.3. Before
taking a unit in for service, you should check to see if any of these hints solve the problem. If these solutions do not rectify
the problem or if the problem recurs, contact your dealer or an authorized Harman Kardon service depot for assistance.

Amplifier will not turn on.

Amplifier turns on, but no audio from
one or more channels.

Audio plays, then cuts off.

• Power Switch turned off.

(Power LED lights red)

• Remote trigger cable not

properly connected.

• Inputs not connected to

proper jack.

• Speakers not connected

properly.

• Improper settings or output

levels from processor or
controller.

• Amplifier shorted (LED

flashes amber and red).

• Turn on Power Switch.

• Verify connection of trigger cable

at both ends.

• Check input connections.

• Check speaker connections.

• Check the settings on your preamp,

processor or controller.

• Check speaker connections for 

short circuit.