HKTS 20 (serv.man5) - Harman Kardon Audio Service Manual (repair manual). Page 8

Read Harman Kardon HKTS 20 (serv.man5) Service Manual online

PL0004-01001
+
+
+
+
+
PL0004-01001
LEFT
SUB
LFE OUT
+
+
+
+
+
+
+
RIGHT
SURROUND
FRONT
CENTER
88
9
Use this installation method for receivers and preamp/processors that have a dedicated 
subwoofer output with low-pass filtering (also called bass management). If the dedicated 
subwoofer output does not have low-pass filtering, follow the instructions in Connecting 
the Subwoofer to a Receiver or Preamp/Processor With Line Outputs,
 on page 9. 
Use the LFE (purple) connector of the supplied combination LFE and trigger cable to 
connect the HKTS200SUB’s Line-Level LFE In Jack 
5
to the dedicated subwoofer output 
(or LFE output) of your receiver or preamp/processor. 
Connect each satellite speaker and the center speaker to the corresponding speaker 
terminals on your receiver or amplifier.
In your receiver or preamp/processor’s setup menu, configure it for Subwoofer ON, and 
set the front left, front right, center, and surround speakers to Small. After you have made 
and verified all connections, plug the HKTS200SUB’s AC Power Cord 
8
 into an active AC 
outlet.
  
Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output
Left Front
Receiver
Left 
Surround
Right 
Surround
Subwoofer
Center
Right Front
Front Left
Speaker Cable
(White Bands)
LFE/Trigger Cable
(Purple Ends)
Surround Right
Speaker Cable
(Gray Bands)
Surround Left
Speaker Cable
(Blue Bands)
Center
Speaker Cable
(Green Bands)
Front Right
Speaker Cable
(Red Bands)
0165CSK - HK HKTS20 and HKTS30 v6.indd   8
08/10/09   13:32:03
harman/kardon
HKTS 20/30/60 -230V Service Manual
Page 8 of 48
Page of 48
Display

Click on the first or last page to see other HKTS 20 (serv.man5) service manuals if exist.