Read Harman Kardon HD 970 (serv.man7) EMC - CB Certificate online
Page 2 of 55
Report No. JSH0503351-001
TRF No: IECEN60065F
TRF originator BEAB
Test case verdicts
Test case does not apply to the test object...............: N/A
Test item does meet the requirement .......................: Pass
Test item does not meet the requirement ..................: Fail
Testing
Date of receipt of test item .....................................:
Date(s) of performance of test………………………:
March 14, 2005
March 14, 2005 – May 17, 2005
General remarks
This report is not valid as a CB Test Report unless signed by an approved CB Testing Laboratory and
appended to a CB Test Certificate issued by a NCB, in accordance with IECEE 02.
This report shall not be reproduced except in full without the written approval of the testing laboratory.
The test results presented in this report relate only to the item(s) tested.
"(see appended table)" refers to a table appended to the report.
“
This report is not valid as a CB Test Report unless signed by an approved CB Testing Laboratory and
appended to a CB Test Certificate issued by a NCB, in accordance with IECEE 02.
This report shall not be reproduced except in full without the written approval of the testing laboratory.
The test results presented in this report relate only to the item(s) tested.
"(see appended table)" refers to a table appended to the report.
“
(see remark #)” refers to a remark appended to the report.
“
(see Annex #) refers to an annex appended to the report.
Throughout this report a comma (point) is used as the decimal separator.
Summary of Testing and Conclusions
The sample(s) tested complies with the requirements of IEC/EN 60065:2002. Compliance with European
Special National Conditions, Annex ZB, and A – Deviations, Annex ZC, is recorded at the end of this report.
Notes:
1. EUT: Equipment under test; U: Test voltage; Un: Rated voltage
2. DI: Double Insulation; BI: Basic Insulation; SI: Supplementary Insulation; RI: Reinforced Insulation
3. SC = Short- Circuit OC = Open-Circuit OE = Outside Of Enclosure IE = Inside Of Enclosure
TW = Transformer Winding TC = Transformer Core PCB = Printed -Circuit Board PW = Primary Wire
NH = No Hazard h= hour min = minute s = second KH = Knob and Handle
O/L
: Overloaded
Click on the first or last page to see other HD 970 (serv.man7) service manuals if exist.